Installation Manual
Table Of Contents
Configuration
Setting the field of view
When the camera is mounted and connected, its field of view
and focus point must be set. To do this:
1. Connect a monitor to the CVBS connector on the rear of
the camera.
2. Start the install wizard.
Camera install wizard
4 5 6 4 5 6
1 2 3 1 2 3
|
|
- +
MENU
CVBS
µSD
E
T
H
-
P
o
E
D
A
T
A
A
L
A
R
M
The
MENU button on the rear panel is used for accessing the
camera install wizard. The wizard fine-tunes the focus and
optimizes picture sharpness in both bright and low-level lighting
(for example, at night).
When there is a choice in the wizard, the options are selected by
either a short press or a longer press of the MENU button.
Select EXIT to close the wizard.
Notice!
Changing the application variant overwrites your camera
settings with the factory defaults.
7
7.1
7.1.1
DINION IP 8000 MP Configuration | en 25
Bosch Security Systems 2014.09 | v1.0 | AM18-Q0665