User Manual
FLEXIDOME IP 3000i IR | FLEXIDOME IP micro
3000i | DINION IP 3000i IR | FLEXIDOME IP turret
3000i IR
Configuration | en 25
Bosch Security Systems B.V. User manual 2020-01 | V02 | DOC
4.3.2 Color
Brightness (0...255)
Adjust the brightness with the slider from 0 to 255.
Contrast (0...255)
Adjust the contrast with the slider from 0 to 255.
Saturation (0...255)
Adjust the color saturation with the slider from 0 to 255.
White balance
– Basic auto mode allows the camera to continually adjust for optimal color reproduction
using an average reflectance method. This is useful for indoor light sources and for
colored LED light illumination.
– Standard auto mode allows the camera to continually adjust for optimal color
reproduction in an environment with natural light sources.
– Sodium lamp auto mode allows the camera to continually adjust for optimal color
reproduction in an environment with sodium vapor light sources (street lighting).
– Dominant color auto mode takes into account any dominant color in the image (for
example, the green of a football pitch or of a gaming table) and uses this information to
obtain a well balanced color reproduction.
– In Manual mode the Red, Green, and Blue gain can be manually set to a desired position.
Apply white balance
Click Hold to put ATW on hold and save the current color settings. The mode changes to
manual.
RGB-weighted white balance
In an auto mode, RGB-weighted white balance can be switched On or Off. When On,
additional fine tuning of the automatic color reproduction can be made with the R, G and B
weight sliders.
R-gain
In Manual white balance mode, adjust the red gain slider to offset the factory white point
alignment (reducing red introduces more cyan).
G-gain
In Manual white balance mode, adjust the green gain slider to offset the factory white point
alignment (reducing green introduces more magenta).
B-gain
In Manual white balance mode, adjust the blue gain slider to offset the factory white point
alignment (reducing blue introduces more yellow).
Note:
It is only necessary to change the white point offset for special scene conditions.
Default
Click Default to set all video values to their factory setting.
4.3.3 ALC
ALC mode
Select the mode for automatic light-level control:
– Fluorescent 50Hz
– Fluorescent 60Hz
– Standard