User Manual

26 en | Configuration
FLEXIDOME IP 3000i IR | FLEXIDOME IP micro
3000i | DINION IP 3000i IR | FLEXIDOME IP turret
3000i IR
2020-01 | V02 | DOC User manual Bosch Security Systems B.V.
ALC level
Adjust the video output level (-15 to 0 to +15).
Select the range within which the ALC will operate. A positive value is more useful for low-
light conditions; a negative value is more useful for very bright conditions.
Exposure
Automatic exposure
Select to let the camera automatically set the optimum shutter speed. The camera tries to
maintain the selected shutter speed as long as the light level of the scene permits.
– Select the Maximum shutter [s] for automatic exposure. (The values available depend on
the value set for the Sensor mode in the Installer Menu).
Fixed exposure
(Only applicable to FLEXIDOME IP 3000i IR, DINION IP 3000i IR and FLEXIDOME IP turret 3000i
IR)
Select the Fixed shutter [s] for fixed exposure. (The values available depend on the value set
for the ALC mode).
Day/Night
Auto - the camera switches the IR cut-off filter on and off depending on the scene illumination
level.
Monochrome - the IR cut-off filter is removed, giving full IR sensitivity.
Color - the camera always produces a color signal regardless of light levels.
Day-to-night switchover
Adjust the slider to set the video level at which the camera in Auto mode switches from color
to monochrome operation (-15 to +15).
A low (negative) value means that the camera switches to monochrome at a lower light level. A
high (positive) value means that the camera switches to monochrome at a higher light level.
Night-to-day switchover
Adjust the slider to set the video level at which the camera in Auto mode switches from
monochrome to color operation (-15 to +15).
A low (negative) value means that the camera switches to color at a lower light level. A high
(positive) value means that the camera switches to color at a higher light level.
(The actual switch-over point might change automatically to avoid instable switching.)
Note:
To ensure stability when using IR illuminators, use the alarm interface for reliable Day/Night
switching.
IR function
(Only applicable to FLEXIDOME IP 3000i IR, DINION IP 3000i IR and FLEXIDOME IP turret 3000i
IR)
Select the control setting for IR illumination:
– Auto: the camera automatically switches the IR illumination.
– On: the IR illumination is always on.
– Off: the IR illumination is always off.
Intensity level
(Only applicable to FLEXIDOME IP 3000i IR, DINION IP 3000i IR and FLEXIDOME IP turret 3000i
IR)
Set the intensity of the IR beam (0 to 30).