User Manual

FLEXIDOME IP 3000i IR | FLEXIDOME IP micro
3000i | DINION IP 3000i IR | FLEXIDOME IP turret
3000i IR
Configuration | en 31
Bosch Security Systems B.V. User manual 2020-01 | V02 | DOC
5. If required, select another region and repeat the steps.
6. To remove a region, select the area and click the waste bin icon.
7. Click Set to apply the region settings.
4.3.9 Privacy Masks
Privacy masking is used to block a specific area of a scene from being viewed. Eight privacy
mask areas can be defined.
1. Select the pattern color for the masks.
2. Select the mask you wish to define in the drop-down box.
3. Check the enabled box to activate the mask.
4. Use the mouse to move the mask; drag the corner points to resize.
5. Click Set.
6. To remove a mask, select it and click the waste bin icon.
Note:
To add an additional adjustment point to the area, double-click on a side.
Click Set to apply the changes.
4.3.10 Audio
You can set the gain of the audio signals to suit your specific requirements. The live video
image is shown in the window to help you check the audio source. Your changes are effective
immediately.
If you connect via Web browser, you must activate the audio transmission on the 'Live'
functions page. For other connections, the transmission depends on the audio settings of the
respective system.
The audio signals are sent in a separate data stream parallel to the video data, and so increase
the network load. The audio data is encoded according to the selected format and requires
additional bandwidth. If you do not want any audio data to be transmitted, select Off.
Audio
Enable or disable the audio recording option.
Microphone volume
(Only applicable to FLEXIDOME IP micro 3000i and FLEXIDOME IP turret 3000i IR)
Adjust the audio level with the slider(s). Adjust so that the indicator does not go into the red
zone.
Input volume
(Only applicable to FLEXIDOME IP 3000i IR and DINION IP 3000i IR)
Adjust the audio level with the slider(s). Adjust so that the indicator does not go into the red
zone.
Line Out
Adjust the audio level with the slider(s). Adjust so that the indicator does not go into the red
zone.
Recording format
Select a format for audio recording. The default value is AAC 48 kbps. You can select AAC 80
kbps, G.711 or L16 depending on the required audio quality or sampling rate.
AAC audio technology is licensed by Fraunhofer IIS.
(http://www.iis.fraunhofer.de/amm/)
Send audio
Audio can be sent via the Send audio button if the unit supports audio. The button activates
the audio backchannel connection.