User Manual

FLEXIDOME IP 3000i IR | FLEXIDOME IP micro
3000i | DINION IP 3000i IR | FLEXIDOME IP turret
3000i IR
Configuration | en 37
Bosch Security Systems B.V. User manual 2020-01 | V02 | DOC
Posting interval
Enter the interval in seconds at which the images are sent to an FTP server. Enter zero for no
images to be sent.
Target
Select the target account for JPEG posting.
Notice!
You must configure an account in order to have functionality for Image Posting. Click on
Configure accounts to do so.
Click Set to apply the changes.
4.4.8 SD Card Status
This section identifies the details about the SD card installed in the device:
– Manufacturer
– Product
– Size
– State
– Lifespan.
Lifespan check
When checked, the Lifespan status is shown in the details of the SD cards.
Lifespan alarm
Set the alarm warning to a defined percentage of the lifespan.
If a SD card is not installed, ‘SD card not found’ is shown.
It is recommended to use an industrial SD card with health monitoring and enhanced
performance. For non-industrial SD cards, the lifespan options are not available.
4.5 Alarm
4.5.1 Alarm Connections
In the event of an alarm, the unit can automatically connect to a pre-defined IP address. The
unit can contact up to ten IP addresses in the order listed until a connection is made.
Connect on alarm
Select On so that the unit automatically connects to a pre-defined IP address in the event of
an alarm.
Number of destination IP address
Specify the numbers of the IP addresses to be contacted in the event of an alarm. The unit
contacts the remote locations one after the other in the numbered sequence until a
connection is made.
Destination IP address
For each number, enter the corresponding IP address for the desired remote station.
Destination password
If the remote station is password protected, enter the password here.
Only ten passwords can be defined here. Define a general password if more than ten
connections are required. The unit connects to all remote stations protected by the same
general password. To define a general password:
1. Select 10 in the Number of destination IP address list box.
2. Enter 0.0.0.0 in the Destination IP address field.