Datasheet

Technical specifications
Electrical
Power Supply 24 VAC 50/60 Hz
12 VDC
Power-over-Ethernet 48 VDC nominal
Current Consumption 1 A (12 VDC)
0.8 A (24 VAC)
0.3 A (PoE 48 VDC)
Power Consumption 12 W
PoE IEEE 802.3af (802.3at Type 1)
Sensor
Type 1/3‑inch CMOS HD
Sensor Pixels 1312 x 1069 (1.4MP)
Video
Video compression H.264 (ISO/IEC 14496-10); M- JPEG,
JPEG
Streaming Multiple configurable streams in H.264
and M-JPEG, configurable frame rate and
bandwidth.
Regions of Interest (ROI)
Overall IP Delay Min. 120 ms, Max. 240 ms
GOP structure IP, IBP, IBBP
Encoding interval 1 to 60 (50) ips
Resolutions (H x V)
• 720p HD 1280 x 720
• D1 4:3 (cropped) 704 x 480
• SD upright
(cropped)
400 x 720
• 480p SD Encoding: 704 x 480;
Displayed: 854 x 480
• 432p SD 768 x 432
• 288p SD 512 x 288
• 240p SD Encoding: 352 x 240;
Displayed: 432 x 240
• 144p SD 256 x 144
Sensitivity (3200 K, scene reflectivity 89%, F1.2)
Minimum illumination (30 IRE)
Color 0.017 lx (0.0017 fc)
Monochrome 0.0057 lx (0.00057 fc)
Day/Night Color, Monochrome, Auto
White Balance ATW (2500 to 10000K), ATWhold and
manual
Indoor and Outdoor ATW
Shutter Automatic Electronic Shutter (AES)
Fixed (1/30 [1/25] to 1/150000)
selectable
Default shutter
Backlight compensation
(IVA)
Off, Auto, IntelligentAE (iAE)
Backlight compensation
(non IVA)
Off, Auto, BLC
Noise reduction Intelligent Dynamic Noise Reduction
(iDNR) with separate temporal and spatial
adjustments
Contrast enhancement On/off
Sharpness Sharpness enhancement level selectable
Dynamic range 84 dB WDR
100 dB WDR (with iAE)
Privacy Masking Four independent areas, fully
programmable
Video Motion Analysis Intelligent Video Analysis
Audio
Standard AAC
G.711, 8kHz sampling rate
L16, 16kHz sampling rate
Signal-to-noise ratio > 50 dB
Audio Streaming Full duplex / half duplex
Input/output
Analog Video out
(service only)
CVBS (PAL/NTSC), 1 Vpp, 2.5 mm jack,
75 Ohm (non-protected)
Audio 1 x mono line in, 1 x mono line out
• connector 3.5 mm stereo jack
• signal line in 12 kOhm typical, 1 Vrms max
• signal line out 1 Vrms at 1.5 kOhm typical,
Alarm 2 inputs
• activation
voltage
+5 VDC to +40 VDC
(+3.3 VDC with DC-coupled 22 kOhm pull-
up resistor)
Relay 1 output
• voltage 30 VAC or +40 VDC max.
Maximum 0.5 A continuous, 10VA
6 | FLEXIDOME IP starlight 7000 RD