Installation Manual
Table Of Contents
- Table of Contents
- 1 Safety
- 2 Introduction
- 3 System Information
- 3.1 Overview of functions
- 3.1.1 Progressive scan
- 3.1.2 Day/Night function
- 3.1.3 Quad-streaming
- 3.1.4 ONVIF (Open Network Video Interface Forum)
- 3.1.5 Audio
- 3.1.6 Alarm I/O
- 3.1.7 Tamper detection and motion detection
- 3.1.8 Video encoding
- 3.1.9 Multicast
- 3.1.10 Power-over-Ethernet
- 3.1.11 Data interface
- 3.1.12 Encryption
- 3.1.13 Recording
- 3.1.14 Configuration
- 3.2 Operation with external systems
- 3.1 Overview of functions
- 4 Planning
- 5 Installation
- 6 Camera configuration
- 7 Browser connection
- 8 Troubleshooting
- 9 Maintenance
- 10 Technical Data
36 en | Camera configuration FlexiDomeHD 1080p IP Camera
AM18-Q0601 | v1.0 | 2012.01 Installation Manual Bosch Security Systems
6 Camera configuration
The camera normally provides an optimal picture without the
need for further adjustments. Configuration of the camera is
carried out via the network using a web browser.
6.1 Day/Night switching
The camera is equipped with a motorized IR filter. The
mechanical IR filter is taken out of the optical path in low-light
applications.
The IR filter is controlled either:
– via an alarm input, or
– automatically, based on the observed light levels.
If Auto switching mode is selected, the camera automatically
switches the filter depending on the observed light level. The
switching level is programmable.
Note:
When the auto mode is selected and the switching level is set
to -15, certain borderline scene lighting conditions can cause
the camera to switch back and forth between day and night
modes. Set a different switching level to avoid this.