Installation Manual
Table Of Contents
- Table of Contents
- 1 Safety
- 2 Introduction
- 3 System Information
- 3.1 Overview of functions
- 3.1.1 Progressive scan
- 3.1.2 Day/Night function
- 3.1.3 Quad-streaming
- 3.1.4 ONVIF (Open Network Video Interface Forum)
- 3.1.5 Audio
- 3.1.6 Alarm I/O
- 3.1.7 Tamper detection and motion detection
- 3.1.8 Video encoding
- 3.1.9 Multicast
- 3.1.10 Power-over-Ethernet
- 3.1.11 Data interface
- 3.1.12 Encryption
- 3.1.13 Recording
- 3.1.14 Configuration
- 3.2 Operation with external systems
- 3.1 Overview of functions
- 4 Planning
- 5 Installation
- 6 Camera configuration
- 7 Browser connection
- 8 Troubleshooting
- 9 Maintenance
- 10 Technical Data
FlexiDomeHD 1080p IP Camera Installation | en 27
Bosch Security Systems Installation Manual AM18-Q0601 | v1.0 | 2012.01
5.4 Mount the camera module
1. Route the cable tree from the camera around the rear of
the camera module and secure all cables.
2. For surface mounted units, place the surface mount ring
over the mounting base.
– With a side connection, remove the tab at the side
entrance; with a rear connection, leave it in place.
3. Use the fixing ring to secure the camera module to the
mounting base:
– Align the screws in the fixing ring with the raised
holes in the mounting base.
– Tighten the three screws with the supplied
screwdriver bit (maximum torque 1 N-m).
x3 x3
> 1 N-m > 1 N-m