Installation Instructions

en-us Installation procedure
12
4.8 OptiSim® feature
The OptiSim® burner cap has been designed to work with
the small burner at the front left position of the cooktop. It
is used to provide optimal simmering for delicate sauces
while minimizing the risk of scorching.
Installing the OptiSim® burner cap
▶
Place the burner cap on the burner base, so that the
lower protrusion locks in place in the center of the
burner base.
a When properly installed the OptiSim® burner cap will
extend beyond the burner base and raised surface.
4.9 Installing the burner grates
WARNING
Improperly positioned grates can cause flare-ups.
▶
Position all grates properly on the cooktop whenever
the cooktop is in use to properly support pots and avoid
spills.
▶
Make sure each of the four feet of the grates is placed
into the corresponding dimples on the cooktop surface.
▶
Do not use a grate if the rubber feet are missing or
damaged.
1. NGM8058UC, NGM8048UC
2. NGM8658UC, NGM8648UC
4.10 Checking the installation
Check if your unit is working properly after you have com-
pleted the installation steps.
WARNING
Before you turn on power supply, make sure all controls
are in the OFF position.
Requirement:The burner caps are properly positioned.
1. Verify that the electric igniters are working.
2. Check the flame characteristics.
The flame should be blue with a minimal yellow tip on
the outer cone.
Flame characteristics
The color of the flame tells you if the gas supply is properly adjusted.
Note:Allow the appliance to operate for 4 to 5minutes before evaluating the flame. Some yellow streaking is normal dur-
ing the initial startup.