Installation Instructions

en-us Conversion to LP gas
14
6. IMPORTANT: Attach the metallic sticker included with
the conversion kit to the bottom of the appliance as
shown. This sticker provides notice that the appliance
has been converted for use with LP gas. It should be lo-
cated near the appliance rating plate.
→ "Rating plate location", Page16
7. If you change the type of gas back to natural gas at a
later point, remove the sticker.
5.2 Replacing the orifices
1. Remove all burner grates, burner caps and burner
bases.
2. Replace the orifices with a 7mm socket wrench. See
burner chart → Page15 .
Normal burner with one orifice
Double burner, first orifice
Double burner, second orifice
It is important to make sure that the orifices do not be-
come detached during removal or fastening.
They must be properly tightened to ensure that there
are no leaks.
The primary air does not have to be adjusted.
3. Fasten the orifices and replace the burner caps to the
corresponding burners.
4. Put the burner grates in place.
5. Save the orifices removed from the appliance for future
use.
5.3 Adjusting the gas valves
1. Turn the control knobs to position off.
2. Carefully lift off the burner grates, remove the burner
caps and the burner bases.
3. Pull off the control knobs.
4. Remove the main top from the cooktop.
5. Remove the electronics pack from the control panel.
6. Remove the white disks from the valve stems.