Operation Manual
Table Of Contents
- Title Page
- Table of Contents
- Browser connection
- System overview
- Operation via the browser
- General settings
- Web Interface
- Camera
- Encoder Settings
- Recording
- Alarm
- Setting up VCA
- Interfaces
- Network
- Service
- Appendices
- Back Page
Browser connection
A computer with Microsoft Internet Explorer is used to receive
live images, control the unit, and replay stored sequences. The
unit is configured over the network using the browser.
System requirements
Our recommendations are:
– Computer with Dual core HyperThreading processor or
better
– Graphic card with performance that matches or is better
than the resolution of the camera
– Windows 7 or later operating system
– Network access
– Internet Explorer version 11 or later
– or –
Application software, for example, Video Security Client,
Bosch Video Client or Bosch Video Management System.
Note:
To see live images in your browser it might be necessary to
download and install the MPEG-ActiveX from the Bosch
download store.
Establishing the connection
The unit must have a valid IP address to operate on your
network and a compatible subnet mask.
By default, DHCP is pre-set at the factory to On plus Link-Local
so a DHCP server assigns an IP address or, if no DHCP server is
available, a link-local address (auto-IP) is assigned within the
range 169.254.1.0 to 169.254.254.255.
(You can use IP Helper or Configuration Manager to find the IP
address.)
1. Start the Web browser.
2. Enter the IP address of the unit as the URL.
1
1.1
1.2
Camera Browser
Interface
Browser connection | en 11
Bosch Security Systems 2016.09 | v1.632 | AM18-Q0718