Operation Manual

Target bit rate
To optimize use of the bandwidth in the network, limit the data
rate for the device. The target data rate should be set according
to the desired picture quality for typical scenes with no
excessive motion.
For complex images or frequent changes of image content due
to frequent movements, this limit can temporarily be exceeded
up to the value entered in the Maximum bit rate field.
Maximum bit rate
The encoder maintains the maximum bit rate over a number of
GOPs (group-of-pictures), limiting image quality when
necessary. To ensure long-term stability of the maximum bit
rate, use the Averaging period under Expert Settings.
The value entered in this field must be at least 10% higher than
the value entered in the field Target bit rate. If the value
entered here is too low, it will be adjusted automatically.
The value in this field is not to be interpreted as the network
transmission bit rate.
Encoding interval
The Encoding interval slider determines the interval at which
images are encoded and transmitted. This can be particularly
advantageous with low bandwidths. The image rate is displayed
next to the slider.
Standard definition video resolution
Select the desired resolution for the standard definition video
image.
Note:
These resolutions are not used by a HD stream.
7.2.4
7.2.5
7.2.6
7.2.7
Camera Browser
Interface
Encoder Settings | en 53
Bosch Security Systems 2016.09 | v1.632 | AM18-Q0718