Operation Manual

Network
The settings on these pages are used to integrate the device
into a network. Some changes only take effect after a reboot. In
this case Set changes to Set and Reboot.
1. Make the desired changes.
2. Click Set and Reboot.
The device is rebooted and the changed settings are activated.
Network Access
If the IP address, subnet mask, or gateway address is changed,
then the device is only available under the new addresses after
the reboot.
Automatic IPv4 assignment
If the network has a DHCP server for the dynamic assignment of
IP addresses, select On or On plus Link-Local to automatically
accept the DHCP-assigned IP address.
If no DHCP server is available select On plus Link-Local to
automatically assign a Link-Local (Auto-IP) address.
For certain applications, the DHCP server must support the
fixed assignment between IP address and MAC address, and
must be appropriately set up so that, once an IP address is
assigned, it is retained each time the system is rebooted.
IP V4 address
IP address
Enter the desired IP address for the camera. The IP address
must be valid for the network.
Subnet mask
Enter the appropriate subnet mask for the set IP address.
Gateway address
For the device to establish a connection to a remote location in
a different subnet, enter the IP address of the gateway here.
Otherwise, this field can remain empty (0.0.0.0).
12
12.1
12.1.1
12.1.2
Camera Browser
Interface
Network | en 87
Bosch Security Systems 2016.09 | v1.632 | AM18-Q0718