Operation Manual
Table Of Contents
- Title Page
- Table of Contents
- Browser connection
- System overview
- Operation via the browser
- General settings
- Web Interface
- Camera
- Encoder Settings
- Recording
- Alarm
- Setting up VCA
- Interfaces
- Network
- Service
- Appendices
- Back Page
The camera uses the TLS 1.0 protocol. Ensure that the browser
has been configured to support this protocol. Also ensure that
Java application support is activated (in the Java Plug-in Control
Panel of the Windows Control Panel).
To limit connections to SSL encryption, set the Off option in the
HTTP browser port, the RCP+ port, and Telnet support. This
deactivates all unencrypted connections allowing connections
on the HTTPS port only.
Configure and activate encryption for media data (video, audio,
metadata) on the Encryption page.
HSTS
Select On to use the web security policy HTTP Strict Transport
Security (HSTS) to provide secure connections.
RCP+ port 1756
Activating RCP+ port 1756 allows unencrypted connections on
this port. To allow only encrypted connections, set the Off
option to deactivate the port.
Telnet support
Activating Telnet support allows unencrypted connections on
this port. To allow only encrypted connections, set the Off
option to deactivate telnet support, making telnet connections
impossible.
Interface mode ETH
If necessary, select the Ethernet link type for interface ETH.
Depending on the device connected, it may be necessary to
select a special operation type.
Network MSS [Byte]
Set the maximum segment size for the IP packet's user data
here. This gives the option to adjust the size of the data packets
to the network environment and to optimize data transmission.
In UDP mode, comply with the MTU value set below.
12.1.8
12.1.9
12.1.10
12.1.11
12.1.12
Camera Browser
Interface
Network | en 89
Bosch Security Systems 2016.09 | v1.632 | AM18-Q0718