Manualshelf

User manual

ManualsBrandsBosch ManualsConsumer electronicsNurseCall Main Unit
31323334353637383940
36 en | Programming NurseCall Main Unit
953.92 | v1.0 | 2007.07 User Manual TeleAlarm SA®
7.1.2 Programming with NPS software
The NurseCall system can be programmed with a specific software, called NPS.
X For connecting and setting the interface, see Section 6.2.6 Connecting the RS-232,
page 31.
Enable the programming
1. Press , then .
2. Confirm the command with .
7.1.3 Exiting the programming mode and cancelling entries
X Press the key once, or several times.
7.1.4 Key not allowed
X If you press a wrong key during the programming, a beep is generated.
i
NOTICE!
In order to program the NurseCall Main Unit with this software, you shall connect your PC to
the NurseCall Main Unit with a RS-232 cable.