User Manual

573700 | REV. B | 03.2016
Bosch Automotive Service Solutions Inc.
OBD1300 Enchanced ODB I & OBD II Scan Tool
|
User guide | 47
|
en
Pedal Position 1 Input Signal
Voltage Is Too Low
HISTORY
3/20
ECM
22
3. Return to Diagnostic Codes Menu.
• Press .
6.5 Erase Codes
The Erase Codes function deletes DTCs and resets I/M
Monitor data from vehicle’s control module(s). Perform
this function with KOEO or KOER. Perform this function
only after the systems have been checked completely and
DTCs have been documented.
After servicing the vehicle, erase stored DTCs and verify
no codes have returned. If a DTC returns, problem has
not been fixed or other faults are present.
Some codes can only be removed by repairing the faults
that caused them. Therefore, these codes remain in the
vehicle’s memory until the condition is repaired.
Not all trouble codes can be automatically erased using
the scan tool. Some vehicles require a manual erasing
procedure (refer to “6.6 Manual Erase Methods” on
page 47). When possible, the tool performs the appro-
priate Erase Codes procedure for your vehicle.
From Diagnostic Codes Menu:
1. Select Erase Codes.
• Use the UP and DOWN keys until Erase
Codes is highlighted.
• Press .
Diagnostic Codes
Read Codes
Erase Codes
Acronyms
Review Data
Print Data
Code Lookup
System Setup
• If diagnostic results and codes are not to be
erased select NO and press .
Erase Codes
Are you sure you want to
erase diagnostic results and
codes?
No
Yes
• Selecting NO displays a “Command cancelled”
message.
Erase Codes
Press ENTER to continue
Command canceled
2. Select YES to erase diagnostic results and codes.
• Use the LEFT arrow key.
• Press .
Erase Codes
Are you sure you want to
erase diagnostic results and
codes?
No
Yes
3. Observe “Command sent” message is displayed.
• Press .
Erase Codes
Press ENTER to continue
Command sent
Codes remaining:0
4. Return to Diagnostic Codes Menu.
• Press .
6.6 Manual Erase Methods
Alternate Method 1:
1. Turn ignition key off.