BOSCH Cooktop MAKERS WARRANTY Booklet designed and produced by DESIGN MAXIM.
Wiring diagram A. B. C. D. E. Switch Blue wire Brown wire Terminal Ignition module Service agent For service to this appliance please call an authorised Bosch service agent or register you fault by phoning us on the numbers listed below. Toll free Melbourne: 1300 30 70 37 (head office) Sales, Customer and Technical Service New Zealand: 0800 4BOSCH 0800 426 724 Sales and Customer Service Robert Bosch (Australia) Pty. Ltd (Incorporated in Victoria) ABN 48 004 315 628 Victoria: Cnr.
Service Trouble shooting chart Contents It is not always necessary to call the Service Centre. In some cases, you may be able to solve the problem yourself. This table contains some useful information. Important: Only authorised personnel from the Service Centre are qualified to work on the main gas and electric systems. Contents ....................................................... 3 Safety considerations ...................................... 4 For your safety .........................................
Safety considerations For your safety • If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. • Do not store articles on or against this appliance. • Do not store flammable materials near this appliance. • Do not spray aerosols in the vicinity of this appliance while it is in operation. What to do if you smell gas • Do not try to light the appliance.
User instructions Boiling burners Use ‘High flame’ setting to bring the pan to the boil, then adjust the flame between ‘High flame’ and ‘Low flame’ to maintain the required pan temperature. Important: The use of a cooktop leads to the production of heat and moisture in the kitchen. For this reason make sure that the room is properly ventilated. Keep natural ventilation openings, such as windows, open or provide a mechanical ventilation device (e.g. a range hood or overhead exhaust fan).
Operating instructions Installation Preparing to install This installation must conform with the following: • Manufacturer’s Installation instructions • Local Gas Fitting Regulations • Municipal Building Codes, • AGA Installation Code for Gas Burning Appliances. (AS 5601/AG 601) • S.A.A. Wiring Code • Local Electrical Regulations • Any other statutory regulations These built-in hobs are intended to be inserted in a benchtop cutout. Only an authorised person should connect the appliance.
Minimum flame adjustment 1 Turn the control knob to minimum. 2 Remove the control knob from the valve spindle. Refer Fig. 8. 3 Using a screwdriver carefully pry off the hard plastic seal. Refer Fig. 9. 4 Using a small screwdriver carefully remove the soft rubber seal. Refer Fig. 10. 5 The adjustment screw is positioned at the rear lower section of the valve. Refer Fig. 11 & 12. 6 To adjust the minimum flame for N.G.
Installation continued Connection Electrical: An electrical 10 amp socket needs to be within 1 m of the hotplate to allow electrical connection. The socket must remain accessible after installation of the appliance. Important note: This appliance is connected to the mains (240 VAC) by means of the connecting lead which must be fixed to the kitchen unit to prevent it from coming into contact with hot parts of the hob (or an oven installed underneath)..
