PCH6A5B90A, PCI6A5B90A, PCR7A5B90A, PCS7A5B90A, PCT9A5B90A, PCR9A5B90A This cooktop is approved for use with Natural Gas and Universal LPG. Leave these instructions with the owner.
en Table of contents no i t c u r t s n I ] ne [ 8 Intended use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 ( Important safety information . . . . . . . . . . . . . . . 4 What to do if you smell gas . . . . . . . . . . . . . . . . . . . . . 4 5 Installation and connection. . . . . . . . . . . . . . . . . 5 Statutory requirements . . . . . . . . . . . . . . . . . . Preparing to install . . . . . . . . . . . . . . . . . . . . . Clearances . . . . . . . . . . . . . . . . . . . . . . . . . .
Intended use 8Intended use Read these instructions carefully. You will only be able to use your appliance safely and effectively when you have read them. These operating and installation instructions should be retained, and passed onto the buyer if the appliance is sold. The manufacturer is exempt from all responsibility if the requirements of this manual are not complied with. The images shown in these instructions are for guidance only.
en Important safety information (Important safety information DO NOT MODIFY THIS APPLIANCE. DO NOT USE OR STORE FLAMMABLE MATERIALS IN THE APPLIANCE STORAGE DRAWER OR NEAR THE APPLIANCE. DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION. DO NOT USE THIS APPLAINCE AS A SPACE HEATER. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
Installation and connection 5Installation and connection Statutory requirements no i t c en o c dna no i t a l a t s n I This installation must conform with the following: ■ Manufacturer’s Installation instructions ■ Local Gas Fitting Regulations ■ Municipal Building Codes ■ Refer to AS/NZS 5601.1 for Gas Installations ■ S.A.A. Wiring Code ■ Local Electrical Regulations ■ Any other statutory regulations D Refer to AS/NZS 5601.1 for piping size details.
Installation and connection en If the base of the hotplate can be touched, a protecting shield must be fitted. F ■ ■ ■ ■ PLQ PLQ The shield must be at least 10 mm from the lowest part of the hotplate and must be capable of withstanding the appliance temperatures. Minimum thickness of benchtop is 30 mm. The shield material must be mdf or similar with minimum thickness of 12 mm. The shield overall dimensions must be 560 mm wide x 480 mm deep.
Installation and connection Depending on the model, the adhesive seal may be factory-fitted. If this is the case, it should not be removed under any circumstances, since the adhesive seal prevents leaks. If the seal has not been factoryfitted, apply it to the underside of the hob. Fitting the appliance onto the kitchen unit: 1. Screw each one of the clips into the position indicated so that they are free to rotate. 2. Insert and centre the hob.
en Installation and connection Gas connection During the planning stage, consider the position of supply connections. The cooktop must be connected to the gas supply with upstream connection of an isolation valve in accordance with the respectively valid regulations. We recommend that the isolation valve be fitted prior to the cooktop to enable isolation of cooktop from gas supply. The valve must be easily accessible at all times.
Installation and connection en Replacing the injectors Request change-over injectors from our customer service deparment (refer injector chart below for sizes). Natural Gas Hourly Gas Injector Consumption mark (MJ) Economy burner Standardoutput burner High-output burner Mini-wok burner Wok burner 4 kW Dual wok burner 5 kW Universal LPG Hourly Gas Injector Consumption mark (MJ) 4 88 3.5 50 6.85 116 6 66 11 153 11 87 13.6 168 10.5 90 15 181 13 98 19.5 190 77 16.
Getting to know your appliance en *Getting to know your appliance Burner locations ecna i l p a ruoy wonk o t gn i t eG 3&+ $ % $ 3&6 $ % $ 1 1 2 2 3&, $ % $ 3&5 $ % $ 1 1 2 2 3&7 $ % $ 3&5 $ % $ 1 1 2 ! Pan supports " Control knobs # Economy burner with an output of up to 1 kW $ Standard-output burner with an output of up to 1.75 kW % High-output burner with an output of up to 3 kW & Mini wok burner up to 3.
Getting to know your appliance Controls and burners Each control knob is marked with the burner it controls. You can use the control knobs to set the output required in each case to various positions between the maximum and the minimum settings. Never try to switch directly from position 0 to position 1 or from position 1 to position 0. en It is essential to ensure that all the burner parts and pan supports are correctly installed for the appliance to work correctly. Do not swap the burner caps around.
en Gas burners Simmer plate This accessory part is only suitable for simmering. It can be used with the economy burner or the standard-output burner. If your hob has several standardoutput burners, we recommend placing the simmer plate on the rear or front-right standard-output burner. Place the accessory component with the projections facing upwards on the holder; never place it directly on the burner. Simmer cap Burner cap that is used only when cooking at minimum output.
Settings table and tips Do not use large pots or heavy weights which can bend the pan support or deflect flame onto the hotplate. Instructions for use Note: When using certain pots or pans, a slight and temporary deformation of the steel cooking surface may occur. This is normal and does not affect the functionality of the appliance. The following recommendations can help you save energy and avoid damaging your cookware: Use pans which are the right size for each burner.
en Settings table and tips This example shows the preparation of fish soup using the high-output burner, the standard-output burner and the wok burner. When using the high-output burner (recommended option), the total cooking time is between 12 and 17 minutes. ■ Step 1: Bring to the boil. Set heat setting 8 for 7-9 minutes. ■ Step 2: Continue boiling. Switch to heat setting 1 for 5-8 minutes. This information also applies for the other suggested burners. Food Burner Total Step 1 time in ˜ § v min.
Settings table and tips Food Burner Total Step 1 time in ˜ § v min.
en Cleaning and maintenance Food Burner Pizza (8 inch) Wok burner Total Step 1 time in ˜ § v min.
Trouble shooting Caution! The stainless steel cleaner must not be used in the area around the controls. The (printed) symbols may be wiped off. en Do not leave acidic liquids (e.g. lemon juice, vinegar, etc.) on the hob. 3Trouble shooting DO NOT MODIFY THIS APPLIANCE. Only authorized personnel from the Service Centre are qualified to work on the appliance. Sometimes certain faults detected can be easily resolved.
en Customer service 4Customer service When contacting our Technical Assistance Service, please provide the product number (E-Nr.) and production number (FD) of the appliance. This information is given on the specifications plate located on the lower section of the hob and on the label in the user manual. After-sales contact details for all countries can be found in the attached after-sales service directory.
3PCFSU #PTDI )BVTHFSÉUF (NC) $BSM 8FSZ 4USBF .ßODIFO (&3.
