Technical data

1 609 929 W64 | (8.7.10) Bosch Power Tools
18 | English
Operation
Starting Operation
Switching On
– To start the operation, press the On/Off button 7 until the
heating indicator 6 lights up green.
Switching Off
– To switch off, press the On/Off button 7 until the heating indi-
cator 6 goes out.
Automatic shut-off:
Note: When the glue gun is not used for more than 5 minutes, it
automatically shuts off.
– Switch the glue gun on again and check the battery charge-con-
trol indicator 8.
When the battery charge-control indicator lights up red contin-
uously, the battery must be recharged.
f After use, place down the glue gun in a safe manner and allow
it to cool down completely before packing it away. The hot
nozzle can cause damage and/or burns.
Working Advice
f Do not allow the hot glue or the nozzle tip to come into con-
tact with persons or animals. Glue and nozzle tip reach a tem-
perature of approx. 200 °C; danger of burning. If hot glue
comes into contact with the skin, hold the affected area imme-
diately under a stream of cold water for several minutes. Do
not try to remove the glue from the skin.
Use only glues recommended by the manufacturer of the glue gun
(see page 112).
Bonded connections can loosen under the effect of moisture.
Preparations for Gluing
The surfaces to be glued must be clean, dry and free of grease.
Heating indicator
green
Meaning

for approx. 15 s
The glue is being heated
{ The glue gun is ready for operation
 Flashing { Continuous light
OBJ_BUCH-1210-001.book Page 18 Thursday, July 8, 2010 3:18 PM