Operating instructions

en
|
14
|
Installation and Operating Instructions
|
Power Xpress Charge Station
EL-50600-7-2 | REV. B | 20.10.2013
Bosch Automotive Service Solutions LLC
Note:
To avoid damage to the Charge Station, place it on a
soft or cardboard surface.
10. Locate the desired conduit-entry point on the
Charge Station housing.
ss01455
11. Drill a pilot hole in the center of the selected knock-
out location.
POWER
STATUS
ss01456
12. Using a 1 1/16-in. (28-mm) hole saw, with the pilot
hole as a guide, drill out the knockout.
CAUTION: Use a mid-range speed setting
and drill carefully to avoid punching
through housing and damaging internal
components.
13. Remove debris from wiring chamber.
ss01457
14. Install a 3/4-in. (19-mm) NPT female adaptor with
nut and seal into the knockout and tighten securely.
15. Secure the Charge Station to the mounted wall
bracket by engaging the tabs on the Charge Station
into the slots on the wall bracket. Press rmly and
slide the Charge Station down until fully seated on
the bracket.
16. Feed the wire from the service panel through the
conduit and into the Charge Station wiring chamber.
ss01459
17. Attach offset conduit to NPT female adaptor.
L2/N
ss01429
18. Remove the strain-relief assembly from the wiring
chamber.
ss01430
19. Trim the wire to a length sufcient to make the con-
nections to the Charge Station terminal block.
ss01431
20. Strip back 1 1/4 in. (32 mm) of the wire jacket and 3/8
in. (10 mm) from the ends of the individual conductors.