Power Max Level 2 Charging Station en Installation and Operating Instructions
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Installation and Operating Instructions | Power Max Level 2 Charging Station | 1 | en Table of Contents Bosch Automotive Service Solutions 1 Introduction 1.1 Applications 2 2 2 Important Safety Warnings and Instructions 2 3 Features and Specifications 3.1 Front View 3.2 Package Contents 3.3 Specifications 3 3 3 4 4 Installation 4.1 Important SAFETY WARNINGS and Instructions 4.2 Grounding Instructions 4.3 Recommended Tools 4.
en | 2 | Installation and Operating Instructions | Power Max Level 2 Charging Station 1 Introduction The Bosch Power Max Level 2 Charging Station is designed for the U.S. market to charge plug-in electric vehicles (PHEV) and battery electric vehicles (BEV). It provides AC Level 2 Charging that effectively shortens charging time for typical electric vehicles (EVs) when compared to the Level 1 Cordset. 1.
Installation and Operating Instructions | Power Max Level 2 Charging Station | 3 | en 3 Features and Specifications 3.1 Front View 3 1 2 4 5 3.2 } } } } 1. STOP button 2. Charging plug and cable `` SAE J1772 compliant 3. Status indicator `` Ready (green LED on) `` Charging (green LED flashing) `` Fault (red LED on) `` Warning (red LED flashing) 4. ON/OFF switch 5.
en | 4 | Installation and Operating Instructions | Power Max Level 2 Charging Station 3.
Installation and Operating Instructions | Power Max Level 2 Charging Station | 5 | en 4 Installation 4.1 Important SAFETY WARNINGS and Instructions IMPORTANT SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS. WARNING Danger of electrical shock or injury. Turn OFF power at the panelboard or load center before working inside the equipment or removing any component. Do not remove circuit protective devices or any other component until the power is turned OFF.
en | 6 | Installation and Operating Instructions | Power Max Level 2 Charging Station 4.4 1. Installing the Power Max Level 2 Charging Station See Figure 4-1. Secure the Level 2 Charging Station mounting bracket to the wall using appropriate screws and bracket holes, as shown in Figure 4-1. Thread 1/4-in. expansion bolts through bracket offset holes into masonry walls as shown and torque to 78 lb·in (8.8 N·m). Thread 2-in., or longer, No.
Installation and Operating Instructions | Power Max Level 2 Charging Station | 7 | en 3. See Figure 4-3. Drill a hole of an appropriate size to accommodate the conduit system fitting in the bottom of the plastic housing as shown. CAUTION Drill the hole carefully to avoid punching through the housing and damaging internal components Place the Level 2 Charging Station on a soft surface during drilling to avoid damage. Figure 4-3. Drilling hole for conduit 4. See Figure 4-4.
en | 8 | Installation and Operating Instructions | Power Max Level 2 Charging Station 5. See Figure 4-5. Align the screw holes of the mounting bracket with the Level 2 Charging Station. Figure 4-5. Alignment of charging station on mounting bracket 6. See Figure 4-6. Install and secure the charging station to the mounting bracket with the three (3) screws supplied. Figure 4-6. Installation screw locations 569217 | REV. A | 05.22.
Installation and Operating Instructions | Power Max Level 2 Charging Station | 9 | en 7. See Figure 4-7. Secure the charging plug to the Level 2 Charging Station. Figure 4-7. Plug attachment with detail of plug dock Bosch Automotive Service Solutions 569217 | REV. A | 05.22.
en | 1 0 | Installation and Operating Instructions | Power Max Level 2 Charging Station 5 Maintenance The exterior of the Power Max Level 2 Charging Station is designed to be waterproof and dust proof with an ingress protection rating of Type 3R. To ensure proper maintenance of the Level 2 Charging Station, follow these guidelines: } } } } } Keep the exterior clean at all times. Do not spray water directly at the Level 2 Charging Station.
Installation and Operating Instructions | Power Max Level 2 Charging Station | 11 | en 6 Operations and Troubleshooting 6.1 Charging 1. See Figure 6-1. Turn the Power Max Level 2 Charging Station power switch to ON. Wait 3 seconds for the green indicator light. Figure 6-1. Powering on the Power Max Level 2 Charging Station and removing the charging plug 2. See Figure 6-2. Release the charging plug from the plug dock and connect it to the EV to start the charging process. Figure 6-2.
en | 1 2 | Installation and Operating Instructions | Power Max Level 2 Charging Station 3. See Figure 6-3. To stop charging before charging is complete, disconnect the charging plug from the EV or press the “Stop” button. Remove and reconnect the charging plug with the EV to start charging again. Figure 6-3. Stop charging 4. See Figure 6-4. When charging is complete, disconnect charging plug from the EV and place it in the plug dock to store the charging cable properly. Figure 6-4.
Installation and Operating Instructions | Power Max Level 2 Charging Station | 13 | en 6.2 Charging Status Indicators LED Status Description Definition Power is off. Off Use the ON/OFF switch on the side of the Level 2 Charging Station to turn on the power. Level 2 Charging Station is ON; charging not in process. Solid green Connect the charging cable to begin charging. Charging in process. Flashing green LED status returns to solid green (above) when charging is complete.
en | 1 4 | Installation and Operating Instructions | Power Max Level 2 Charging Station 6.3 Troubleshooting Situation Status indicator is not green after the Level 2 Charging Station is powered on Action 1. Make sure the AC power input is connected correctly. 2. Turn OFF the Level 2 Charging Station and then back ON using the ON/OFF switch. 3. If the problem persists, contact Technical Support. 1.
Installation and Operating Instructions | Power Max Level 2 Charging Station | 15 | en 7 Important Notices 7.1 Limited Warranty THIS WARRANTY IS EXPRESSLY LIMITED TO THE ORIGINAL PURCHASER OF THE POWER MAX LEVEL 2 CHARGING STATION (“POWER MAX”). } Power Max is warranted against defects in materials and workmanship for one year from the date of delivery. } Power Max Cables and Connectors are warranted against defects in materials and workmanship for 90 days from the date of delivery.
en | 1 6 | Installation and Operating Instructions | Power Max Level 2 Charging Station 7.5 Technical Support If technical support is required, contact Bosch at: 1-877-805-EVSE (3873) www.pluginnow.com 569217 | REV. A | 05.22.
Bosch Automotive Service Solutions 28635 Mound Road Warren, MI 48092 USA Phone: (877) 805-EVSE (3873) www.pluginnow.
