Installation Instruction
Table Of Contents
- Ú Installation instructions
- : Important safety information
- Wearers of electronic implants!
- Danger of death!
- Risk of death!
- Danger of suffocation!
- Exhaust air mode
- Exhaust duct
- Electrical connection
- Checking the fitted unit
- Preparing the units
- Preparing for the electrical connection work
- For air extraction mode: Insert the hob and establish the pipework (Fig. 6a)
- 1. Secure the seal to the exhaust air duct. Secure the seal no more than 5 mm from the edge.
- 2. Do not use silicone for sealing.
- 3. Attach the seal to the cut-out in the back panel of the unit.
- 4. Adjust the appliance to the built-in niche in the front section.
- 5. Carefully insert the appliance into the unit cut-out.
- 6. Insert the exhaust air duct into the ventilation opening on the rear of the appliance.
- For circulating-air mode: Insert the hob and connect the pipework between the appliance and the rear panel of the unit (Fig. 6b)
- Caution!
- 1. Insert the adapter into the outlet opening at the rear of the cooktop.
- 2. Remove the protective film on the adhesive tape from the adapter.
- 3. Do not use silicone for sealing.
- 4. Adjust the appliance to the built-in niche in the front section.
- 5. Carefully insert the appliance into the unit cut-out.
- 6. In the floor unit, push the adapter by the side holders against the rear panel of the unit and stick it securely. When doing so, hold the adapter by the middle holder. If necessary, secure it in place using screws.
- Caution!
- In guided circulating-air mode: Insert the hob and the air extraction channels with the diffuser. (Fig. 6c)
- 1. When using the air recirculation duct: Secure the seal to the air recirculation duct. Secure the seal no more than 5 mm from the edge.
- 2. Do not use silicone for sealing.
- 3. Adjust the appliance to the built-in niche in the front section.
- 4. Carefully insert the appliance into the unit cut-out.
- 5. Connect the components of the air recirculation duct and insert it into the outlet opening at the rear of the hob.
- 6. Connect the diffuser to the air recirculation duct.
- Connecting the appliance
- Connecting the air extractor
- Inserting the filter
- Establishing a connection to the mains
- 1. If —…‹‹, “‹†‚„ or “ appears in the appliance display, it is not connected correctly. Disconnect the appliance from the power supply and check whether the connection to the appliance (Fig. 4) and the connection to the building (...
- 2. If no fault appears in the display of the appliance, check the function of the ventilation system according to the instruction manual.
- Switching the display to air extraction mode or air recirculation mode
- Removing the appliance
