Hob PXY...D...
: : : : : : : : ,(& 2 Ø = cm
en Table of contents no i t c u r t s n I ] ne [ 8 Intended use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 ( Important safety information . . . . . . . . . . . . . . . 5 ] Causes of damage . . . . . . . . . . . . . . . . . . . . . . . . 6 z Keep warm function . . . . . . . . . . . . . . . . . . . . . . 19 Activating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19 Deactivating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
en Intended use 8Intended use Read these instructions carefully. Please keep the instruction and installation manual, as well as the appliance certificate, in a safe place for later use or for subsequent owners. Check the appliance after removing it from the packaging. If it has suffered any damage in transport, do not connect the appliance, contact the Technical Assistance Service and provide written notification of the damage caused, otherwise you will lose your right to any type of compensation.
Important safety information (Important safety information : Warning – Risk of fire! no i t amro f n i y t e f as t na t ropmI Hot oil and fat can ignite very quickly. Never leave hot fat or oil unattended. Never use water to put out burning oil or fat. Switch off the hotplate. Extinguish flames carefully using a lid, fire blanket or something similar. Risk of fire! ■ The hotplates become very hot. Never place combustible items on the hob. Never place objects on the hob.
en Causes of damage ]Causes of damage Caution! ■ Rough pan bases may scratch the hob. ■ Avoid leaving empty pots and pans on the hotplate. Doing so may cause damage. ■ Do not place hot pans on the control panel, the indicator area, or the hob frame. Doing so may cause damage. ■ Hard or pointed objects dropped on the hob may damage it. ■ Aluminium foil and plastic containers will melt if placed on the hotplate while it is hot. The use of laminated sheeting is not recommended on the hob.
Environmental protection 7Environmental protection In this section, you can find information about saving energy and disposing of the appliance. no i t ce t orp l a t nemnor i vnE Energy-saving advice ■ ■ ■ ■ ■ ■ Always use the correct lid for each pan. Cooking without a lid uses a lot more energy. Use a glass lid to provide visibility and avoid having to lift the lid. Use pans with flat bases. Bases that are not flat use a lot more energy.
en Induction cooking Some induction cookware does not have a fully ferromagnetic base: ■ ■ If the base of the cookware is only partially ferromagnetic, only the area that is ferromagnetic will heat up. This may mean that heat will not be distributed evenly. The non-ferromagnetic area may not heat up to a sufficient temperature for cooking. The ferromagnetic area will also be reduced if the material from which the base of the cookware is made contains aluminium, for example.
Getting to know your appliance en *Getting to know your appliance You can find information on the dimensions and power of the hotplates in~ Page 2 ecna i l p a ruoy wonk o t gn i t eG The control panel Displays Controls # ã Main switch 0 1Ê2Ê...
Getting to know your appliance en The hotplates Hotplates Û á à/ß Simple hotplate Use cookware that is a suitable size. Flexible cooking zone See section ~ "Flex Zone" FlexPlus cooking zone The FlexPlus cooking zone always switches on in conjunction with the right- or left-hand flexible cooking zone.
Operating the appliance 1Operating the appliance This chapter explains how to set a hotplate. The table shows heat settings and cooking times for various meals. en Changing the heat setting Select the hotplate and then set the required heat setting in the control panel. ecna i l p a eh t gn i t arepO Switching the hob on and off The main switch is used to switch the hob on and off. To switch on: Touch the # symbol. An audible signal sounds.
en Operating the appliance Cooking table The table shows which heat setting is suitable for each type of food. The cooking time may vary depending on the type, weight, thickness and quality of the food. Heat setting Cooking time (mins) Melting Chocolate coating Butter, honey, gelatine 1 - 1.5 1-2 - Heating and keeping warm Stew, e.g. lentil stew Milk* Heating sausages in water* 1.5 - 2 1.5 - 2.
Operating the appliance Roasting/frying with little oil* Escalope, plain or breaded Escalope, frozen Chop, plain or breaded** Steak (3 cm thick) Poultry breast (2 cm thick)** Poultry breast, frozen** Rissoles (3 cm thick)** Hamburgers (2 cm thick)** Fish and fish fillet, plain Fish and fish fillet, breaded Fish, breaded and frozen, e.g.
en Flex Zone As two independent hotplates |Flex Zone You can use the hob as a single hotplate or as two independent hotplates, as required. It consists of four inductors that work independently of each other. If using the flexible cooking zone, only the area that is covered by cookware is activated. The flexible cooking zone is used like two independent hotplates.
Move function uMove function This function activates the entire flexible cooking zone, which is divided into three cooking areas and which has preset heat settings. Only use one item of cookware. The size of the cooking area depends on the cookware used and whether it is positioned correctly. no i t cnu f evoM Cooking areas en Activation 1. Select one of the two hotplates in the flexible cooking zone. 2. Touch the ç symbol. The indicator beside the ç symbol lights up.
en FlexPlus Zone }FlexPlus Zone The hob has a FlexPlus cooking zone which is located between the two flexible cooking zones and which switches on in conjunction with the right- or left-hand flexible cooking zone. This means that larger cooking vessels can be used and better cooking results can be achieved. The FlexPlus cooking zone always switches on in conjunction with one of the two flexible cooking zones. It is not possible to activate these cooking zones independently.
Time-setting options OTime-setting options Your hob has three timer functions: sno i t po gn i t es -emi T ■ ■ ■ Programming the cooking time Kitchen timer Stopwatch function Programming the cooking time The hotplate automatically switches off after the time that is set has elapsed. Setting procedure: 1. Select the hotplate and the required heat setting. 2. Touch the y symbol. The ‹‹ symbol and theV indicator light up in the timer display. y lights up in the display for the hotplate.
en PowerBoost function Stopwatch function The stopwatch function displays the time that has elapsed since activation. This functions independently from the hotplates and from other settings. This function does not automatically switch off a hotplate. Activating Touch the x symbol. The ‹‹ symbol and the V indicator light up in the timer display. The cooking time begins to elapse.
ShortBoost function xShortBoost function The PowerBoost function enables you to heat cookware faster than when using heat setting Š. no i t cnu f t so Bt rohS After deactivating the function, select the appropriate heat setting for your food. This function can always be activated for a hotplate, provided the other hotplate in the same group is not in use (see illustration). en zKeep warm function This function is suitable for melting chocolate or butter and for keeping food warm.
en Transferring settings sTransferring settings The heat setting and the programmed cooking time can be transferred from one hotplate to another using this function. To transfer the settings, move the cookware from the hotplate which is switched on to another hotplate. s gn i t e s gn i r e f s na r T cFrying Sensor This function can be used to fry food while maintaining the suitable frying pan temperature. The cooking zones that have this function are identified by the roasting function symbol.
Frying Sensor en Temperature settings Temperature setting 1 Very low 2 Low 3 Medium - low 4 Medium - high 5 High Suitable for Preparing and preserving sauces, sweating vegetables and frying food in extra virgin olive oil, butter or margarine. Frying food using extra virgin olive oil, butter or margarine, e.g. omelettes. Frying fish and Thick food, e.g. meatballs and sausages. Frying steaks, medium or well-done, frozen, breaded and fine foods, e.g. escalope, fresh ragout and vegetables.
en Frying Sensor Temperature Total frying time after the signal setting sounds (mins.) Potatoes Fried potatoes (boiled in their skin) French fries (made from raw potatoes) Potato fritter** Swiss rösti Glazed potatoes 5 4 5 1 3 6 - 12 15 - 25 2,5 - 3,5 50 - 55 15 - 20 Vegetables Garlic, onions Courgettes, aubergines Peppers, green asparagus Vegetables sautéed in oil, e.g.
Childproof lock Setting procedure Select the appropriate temperature setting from the table. Place the empty frying pan on the hotplate. en AChildproof lock You can use the childproof lock to prevent children from switching on the hob. kco l f o rpd l i hC 1. Select the hotplate. Touch the é symbol.é lights up in the hotplate display. Activating and deactivating the childproof lock The hob must be switched off. To activate: 1. Switch on the hob using the main switch. 2.
en Wipe protection kWipe protection If you wipe over the control panel while the hob is switched on, settings may be altered. To avoid doing this, you can use the hob's "Lock control panel for cleaning" function. n o i t c e t o r p e p iW To switch on: Touch the > symbol. An audible signal sounds. The control panel is locked for 35 seconds. You can now wipe over the surface of the control panel without altering any settings.
Basic settings en QBasic settings The appliance has various basic settings. You can adapt these to suit your cooking habits. sgn i t es c i saB Display Function ™‚ Automatic childproof lock ‹ ‚ ƒ ™ƒ Audible signals ‹ ‚ ƒ „ ™„ Confirmation and fault signals are switched off. Only the fault signal is switched on. Only the confirmation signal is switched on. All signal tones are switched on.* Display energy consumption ‹ ‚ ™† Manual*. Automatic. Function deactivated. Switched off.* Switched on.
Basic settings en Display Function ™‹ Restoring the factory settings ‹ ‚ Individual settings.* Restore factory settings. * Factory settings To access the basic settings: 6. Touch the The hob must be off. The settings have been saved. 1. Switch on the hob. 2. Within ten seconds, touch and hold the t symbol for approximately four seconds. The first four displays provide product information. Touch the settings area to view the individual displays.
Energy consumption indicator [Energy consumption indicator This function indicates the total amount of energy consumed by this hob the last time it was used for cooking. Once switched off, the energy consumption in kWh is displayed for 10 seconds. The picture shows an example with an energy consumption of ‚.‹‰ kWh. ro t ac i dn i no i t pmusnoc ygrenE en tCookware check This function can be used to check the speed and quality of the cooking process depending on the cookware.
Cleaning en DCleaning Suitable maintenance and cleaning products can be purchased from the after-sales service or in our e-Shop. gn i nae l C Hob Cleaning Always clean the hob after cooking. This will prevent food deposits from becoming burned on. Only clean the hob after the residual heat indicator has gone out. Clean the hob with a damp dish cloth and dry it with a cloth or towel to prevent limescale build-up. Only use cleaning agents that are suitable for this type of hob.
Frequently Asked Questions (FAQ) en {Frequently Asked Questions (FAQ) )QAF( sno i t seuQ deksA y l t neuqerF Using the appliance Why can't I switch on the hob and why is the childproof lock symbol lit? The childproof lock is activated. You can find information on this function in the section on ~ "Childproof lock" Why are the displays flashing and why can I hear an audible signal? Remove any liquid or food remains from the control panel. Remove any objects from the control panel.
en Trouble shooting Cleaning How do I clean the hob? Using a special glass-ceramic cleaning agent produces the best results. We advise against using harsh or abrasive cleaning agents, dishwater detergent (concentrated) or scouring pads. You can find more information on cleaning and caring for your hob in the section on ~ "Cleaning" 3Trouble shooting Usually, faults are small matters that are easy to eliminate. Please read the information in the table before calling the after-sales service.
Customer service Notes ■ If “ appears in the display, the sensor for the relevant hotplate must be pressed and held in order to read the fault code. ■ If the fault code is not listed in the table, disconnect the hob from the power supply, wait 30 seconds and connect it again. If the display appears again, contact technical after-sales and tell them the precise fault code. en 4Customer service Our after-sales service is there for you if your appliance needs to be repaired.
en Test dishes ETest dishes This table has been produced for test institutes to facilitate the testing of our appliances. The data in the table refers to our Schulte-Ufer cookware accessories (4 piece cookware set for the HEZ 390042 induction hob) with the following measurements: s e h s i d t s eT ■ ■ ■ ■ Saucepan Ø 16 cm, 1.2 l for hotplates of Ø 14.5 cm Pot Ø 16 cm, 1.7 l for hotplates of Ø 14.5 cm Pot Ø 22 cm, 4.
Test dishes Test dishes Preheating Heat set- Cooking time Cookware Lid ting (min:sec) Cooking rice pudding Rice pudding, cooked with the lid on Temperature of the milk: 7 ºC Heat the milk until it starts to rise up. Set the recommended heat setting and add rice, sugar and salt to the milk. The cooking time, including preheating, is approx. 45 minutes. Ingredients: 190 g short-grain rice, 90 g sugar, 750 ml milk (3.
3PCFSU #PTDI )BVTHFSÉUF (NC) $BSM 8FSZ 4USBF .ßODIFO (&3.
