Specifications

Control panel installation
Install the enclosure and wiring label
Refer to Enclosures, page 96
to determine if the application requires a specific enclosure.
Installing the enclosure:
1. Remove any knockouts prior to installing the control panel.
2. Mount the enclosure in the desired location. Use all enclosure mounting holes. Refer to
the mounting instructions supplied with the selected enclosure.
3. Pull the wires into the enclosure.
Notice!
Electromagnetic interference (EMI) can cause problems on long wire runs.
4. Install the supplied Enclosure Wiring Label (B5512/B4512/B3512) on the inside of the
enclosure door.
1 2 3
4
22 5
2
3
Figure 5.1: Enclosure and control panel mounting (B10 shown)
Callout ᅳ Description
1 ᅳ Control panel wiring label
2 ᅳ Enclosure mounting holes (4)
3 ᅳ Module mounting locations (4)
4 ᅳ Tamper switch mounting location
5 ᅳ Control panel mounting location
Install the control panel
Mount the control panel
1.
Identify the control panel mounting location in the enclosure.
5
5.1
5.2
5.2.1
Control Panel Control panel installation | en 25
Bosch Security Systems, Inc. Installation and System Reference Guide 2014.05 | 11 | F.01U.287.180