Specifications

-11-
!#
Use only diamond cut-off
(type 1) wheels or Rotozip®
XWHEELS™. Bonded abrasive wheels may
burst, causing fragments to fly away at great
velocity possibly striking you or bystanders.
Always use included guard
and guard cover when
cutting.
Disconnect tool from power source. Be sure
that wheel guard is in place for cutting.
$?!
Thread backing flange onto spindle, then
place standard lock nut on spindle (Fig. 4).
Tighten standard lock nut using the included
spanner wrench while holding the spindle
lock. Standard lock nut becomes backing
flange for Rotozip® cut-off wheels.
Place wheel on standard lock nut, making
sure to center wheel on lock nut.
Thread on Rotozip® washer and lock bolt
and tighten using included hex wrench while
holding the spindle lock (Fig. 4 & 5).
If performing a standard cut-off, attach guard
cover and rotate counter-clockwise to lock
into place. If performing a flush cut, do not
attach the guard cover (Fig. 6).
TO REMOVE: Reverse procedure.
B#!
Thread backing flange onto spindle, then place
wheel onto spindle.
Thread standard lock nut onto spindle and
tighten using the included spanner wrench
while holding the spindle lock.
Store your Rotozip® lock nut by threading it
onto the included spanner wrench.
!
WARNING
!
WARNING
BACKING
FLANGE
SPINDLE
STANDARD
LOCK NUT
XWHEEL
LOCK
BOLT
SPINDLE LOCK
GUARD COVER
FIG. 4
FIG. 5
FIG. 6
ZIP WHEEL
WASHER
BM 2610008432 08-10:BM 2610008432 07-10 7/29/10 10:08 AM Page 11