Installation guide

28 en | Installing RPS RPS
4998141259 | 09 | 2008.10 Installation Guide Bosch Security Systems, Inc.
3.4 Installing RPS with SQL Server or SQL Express
3.4.1 New Installations for Standalone PCs
Use the following steps on a standalone PC to install RPS for the first time, or to replace a
previous version that was removed using Add/Remove Programs.
1. Unless the PC already has SQL Express installed, install SQL Express from the RPS CD-
ROM. Refer to Section 3.3 Installing RPS Together with SQL Express on page 12.
2. Select the RPS installer from the RPS installation CD-ROM, or select Install RPS from the
RPS instruction dialog.
3. Select your setup language preference, then click OK.
The RPS InstallShield® Wizard opens.
Figure 3.34 RPS Choose Setup Language
i
NOTICE!
Networking protocols are disabled by default in SQL Server Express. If someone simply
installs SQL Server Express and chooses all the defaults, SQL Server Express can only have
connections originating on the local machine where SQL Server is installed.
To enable SQL Server Express to accept remote connections, configure SQL Server Express to
listen on TCP/IP:
– Launch the SQL Server Configuration Manager from the Microsoft SQL Server 2005
program menu.
– Click the Protocols for SQLEXPRESS node.
– Right-click on TCP/IP in the list of protocols, then select Enable.
– In the SQL Server Configuration Manager, click the SQL Server 2005 Services node.
– Right-click on SQL Server Browser and select Properties.
– Click the Start button to start the SQL Server Browser.
– Select the Service tab, and set Sart Mode to Automatic.
i
NOTICE!
If SQL Express is already installed, you do not need to install SQL Server 2005.
If SQL Server 2005 is already installed, you do not need to install SQL Express.