Instruction manual
aus
6
Selecting language
The language in the display window
11
can be set from to . “Deutsch”
is the factory setting.
Language
Setting
Deutsch L:01
English L:02
Français L:03
Nederlands L:04
Italiano L:05
ÅËËÇÍÉÊÁ L:06
Español L:07
Português L:08
Svenska L:09
Norsk L:10
Suomi L:11
Dansk L:12
Türkçe L:13
PYCCÅ L:14
Polski L:15
Èe. L:16
Magyar L:17
Croatian L:18
Slovenian L:19
To change the language:
Open the door.
Switch on ON/OFF switch
1
.
Hold down programme button
A
and press START button
9
until the
digital display
3
is indicated.
Release both buttons.
Press programme button
A
until
the factory set value is indicated
on the digital display
3
.
“Deutsch” is indicated in the display
window
11
.
Press programme button
C
.
Each time the button is pressed,
the set value increases by 1; after
, the setting goes back to .
Press START button
9
.
The set value is saved.
Close the door.
Rinse aid
As soon as the rinse-aid refill indicator
5
lights up on the control panel,
refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses.
Use only rinse aid for domestic dish-
washers.
Combined detergents with rinse-aid com-
ponent may be used up to a water hard-
ness of 21 _dH (37 _fH, 26 _Clarke,
3,7 mmol/l) only. If the water hardness
is over 21 _dH, rinse-aid must be used.
Open the dispenser
28
by pressing
and lifting the plate on the cover.
Carefully pour rinse aid up to the max.
mark in the filler opening.
Close cover until it clicks shut.
To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.