User`s guide

Turning the System All On

Use this function to turn on the entire system. Once you press the [9] key,

exit delay time starts to count down. The length of exit delay time is

programmed by your security company. Check with them to learn how

much exit delay time your system allows. In this example, exit delay is 30

seconds. You should leave before exit delay time expires. Leaving after exit

delay expires causes an alarm event.

1. Make sure that all points are normal (not faulted).

2. Press the [9] key. If all points are normal, exit delay time begins.

You should leave now. If your system has a faulted point, you

should return the point to normal, or refer to Bypassing Points (on

page 16).

30 SEC TO EXIT!

During exit delay, you may stop the system from turning on by

pressing [CLEAR]:

TO STOP

PRESS CLEAR

If you wish to, you can turn the system All On with No Delay by

pressing the [9] key again:

FOR NO DELAY

PRESS 9

If you wish to, you may bypass points by pressing the [∗] key. The

system prompts you through the procedure:

TO BYPASS POINTS

PRESS ∗

3. When exit delay time expires, the keypad beeps three times and the

system turns on.

ALL ON

SYSTEM OK

4. To turn the system off, enter your personal passcode.