User`s guide

Turning On Part of the System (Part On)

I have this feature.

I do not have this feature.

Part On turns on only a part of your system, leaving the rest of the system

turned off. Refer to the Point Identification section of your keypad’s

reference card to identify Part points. Once you’ve pressed the [0] key, exit

delay time starts to count down. You should leave before exit delay time

expires. Leaving after exit delay expires causes an alarm event. Use Part On

when you want part of your system turned on.

1. Make sure Part points are normal (not faulted).

2. Press the [0] key. If all Part points are normal, exit delay time

begins. If your system has faulted points, you should return them to

normal, or refer to Bypassing Points (on page 16).

30 SEC TO EXIT!

During exit delay, you may stop the system from turning on by

pressing [CLEAR]:

TO STOP

PRESS CLEAR

If you wish to, you can turn the system Part On with No Delay by

pressing the [0] key again:

FOR NO DELAY

PRESS 0

If you wish to, you may bypass points by pressing the [∗] key. The

system prompts you through the procedure:

TO BYPASS POINTS

PRESS ∗

3. When exit delay time expires, the keypad beeps three times and

then the system turns on.

PART ON

SYSTEM OK

4. To turn the system off, enter your personal passcode.