User`s guide

16
Turning the System Part On, with No Delay
I have this feature.
I do not have this feature.
Use this function to turn on part of the system without entry or exit delays.
Remember that turning the system On with No Delay allows no exit or
entry delay time through the designated delay door.
1. Make sure that Part points are normal (not faulted).
2. Press the [0] key twice. If all Part points are normal, the display
shows the following for 3 sec. and the keypad beeps three times. If
your system has faulted points, you should return them to normal,
or refer to Bypassing Points (on page 16).
TO STOP
PRESS CLEAR
3. After 3 sec. the system turns on.
PART ON NO DELAY
SYSTEM OK
4. To turn the system off, enter your personal passcode.
Turning the System On, with Points Open
(Bypassing Points)
I have this feature.
I do not have this feature.
The Bypass Points feature excludes points you do not wish to turn on with
the rest of the system. If you try to turn your system on and there is a
faulted point (door or window open), you can either close it or bypass it. If
a point becomes faulted after exit delay begins, you must close the point,
bypass it, or cancel exit delay. If the system is allowed to turn on with a
point faulted, an alarm is generated. If you wish, you can bypass a point
even if it is not faulted.