User`s guide

17
1. Press the [9] or [0] key to turn the system All or Part On.
2. If a point is faulted, the error tone sounds and the following display
is shown for 3 seconds:
POINTS FAULTED
If a point becomes faulted after exit delay has begun, the display
shows the following. Go to Step 3:
POINTS FAULTED
## SEC TO EXIT!
3. The system then identifies the faulted point (in this example, point
5), followed by instructions for bypassing the point:
POINT 5 FAULTED
BEDROOM WINDOW
PRESS 5∗ TO
BYPASS PT 5
4. Press the key for the point you want to bypass and then the [∗] key.
In this example, you would press [5] [∗]. The display shows you
bypassed the point.
PT 5 BYPASSED
BEDROOM WINDOW
5. If there are other faulted points, they are displayed in turn. If there
are no more faulted points, exit delay begins. The display indicates
the system is being turned on with a bypassed point:
30 SEC TO EXIT!
1 PTS BYPASSED
6. If you bypass a point in error, press [CLEAR] and start over at
step 1.
7. Turning the system off clears all bypassed points.