User`s guide

32
System Test
I have this feature.
I do not have this feature.
This feature helps ensure your system is operating properly by testing the
system’s bell, battery, and phone line. If any of these components fails the
test, contact your security company for assistance. Be sure to contact your
security company before you begin.
1. Make sure the system is turned off (On light is off).
2. Press the [1] key. The display shows:
ENTER CODE TO
START TEST
3. Enter your passcode (Owner type required). If your passcode is
valid, the system test begins. The bell is the first component to be
tested. It should ring for approximately 3 seconds:
TESTING BELL
4. The next component to be tested is the battery. This test may take
up to 4 minutes:
TESTING BATTERY
MAY TAKE 4 MIN.
If the battery passes the test, the display shows:
BATTERY TEST
PASSED
If the battery test fails, the display shows:
BATTERY TEST
FAILED
5. Finally, the phone connection is tested. This test may take up to 10
minutes:
TESTING PHONE
MAY TAKE 10 MIN.
If the phone line passes the test, the display shows:
PHONE TEST
PASSED