User Guide

Basic Operation en-us
31
¡ You can only change a cycle in
progress if you can cancel it
first.
→ "Terminating the wash cy-
cle", Page31
¡ To save energy, the appliance
switches off automatically
10minutes after the end of the
wash cycle. If you open the ap-
pliance door immediately after
the wash cycle has ended, the
appliance will switch off after 4
seconds.
13.7 Activating the button
lock
The button lock prevents the ap-
pliance from being operated acci-
dentally or incorrectly while run-
ning.
▶
Press for approx. 3sec-
onds.
a The button lock is activated and
will be automatically deacti-
vated at the end of the cycle.
a flashes on the display
when the appliance is running.
a The button lock remains acti-
vated with a power failure.
13.8 Deactivating the
button lock
▶
Press for approx. 3sec-
onds.
13.9 Interrupting the wash
cycle
1. Press On/Off.
The program is saved and the
appliance switches off.
2. Press On/Off.
3. Press to resume the wash
cycle.
13.10 Terminating the
wash cycle
To end a cycle early or to switch
from one that has already started,
you will need to cancel it first.
▶
Press for approx.
4seconds.
a All displays light up.
a As soon as the displays are off,
the display shows "0h:01m"
and the residual water is
pumped out.
a The cycle is cancelled and
ends after approx. 1minute.
13.11 Switching off the
appliance
CAUTION
To avoid risk of injury, always use
caution when opening the door
during or following a wash cycle
as hot water or steam may es-
cape.
▶
Do not fully open the door until
water noises have stopped and
steam has subsided.
1. Please note the information on
Preventing Material Damage
→ Page9 .
2. Press On/Off.