Installation Guide

Your dishwasher comes with either a two-piece or three-

piece toe panel (model dependent) to allow height adjust-

ment.

1. Position the slotted rear toe panel (part of E) on the

dishwasher rst. Allow it to rest on the oor.

Position the mating front toe panel (part of E) on top of

the rear toe panel allowing the angled edge to rest on

the mating edge of the dishwasher.

Drive the two black screws (B) through the

holes in the

toe panel to secure. Use the supplied screws to avoid

damaging the dishwasher. See Figure 22

For models with outer toe panel (3rd piece - L) slide the

brackets (K) provided, into the slots of the toe panel you

just attached.

6. Once you determine the correct position for the brackets,

remove the bracket and bend the metal tab. See Figure

23. This ensures that the toe panel will not slide in further

than you need.

7. Re-insert the brackets.

8. Attach the outer toe panel (L) onto the brackets and drive

the screws provided (F) in place to secure the toe panel.

Figure 23

Attaching the Toe Panel

Figure 22