Interactive User Manual
Table Of Contents
- Table of contents
- en-us Operating instructions
- ( Safety Definitions 5
- ( IMPORTANT SAFETY INSTRUCTIONS 6
- ƒ Causes of Damage 10
- * Getting Started 11
- , Rinse Aid 14
- - Loading the Dishwasher 16
- . Detergent 22
- / Dishwasher Cycles 24
- 0 Dishwasher Cycle Options 25
- 1 Operating the Dishwasher 26
- 2 Care and Maintenance 30
- 3 Troubleshooting 34
- 4 Customer Service 39
- ‡ Statement of Limited Product Warranty 40
- ( Safety Definitions
- en-us Operating instructions
- ( IMPORTANT SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- READ AND SAVE THESE INSTRUCTIONS
- To reduce the risk of fire, electrical shock, or serious injury, observe the following:
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 CAUTION
- ƒ Causes of Damage
- * Getting Started
- , Rinse Aid
- Rinse Aid
- Note:
- Adding rinse aid
- NOTICE
- 1. Open the rinse aid dispenser 1b by pressing on the latch of the lid and pull it open.
- 2. Add liquid rinse aid to the dispenser 1b until it is full. Do not overfill. Avoid spilling into air vent hole.
- 3. Close the lid. Lid must be fully closed until it clicks in order to seal.
- 4. Wipe up any excess rinse aid that may have puddled when the dispenser reservoir is full.
- Tip:
- NOTICE
- Setting the amount of rinse aid used
- Setting
- Amount
- 1. Press the On/Off button (.
- 2. Hold down the selection button > X and press the Start button h until the display H indicates •:‹x (x can be any number). Release both buttons.
- 3. Press the selection button > Xuntil the display H shows §:‹†.
- 4. Press the selection button < 8to select the desired setting.
- 5. Press the Start button h to save the setting.
- Turning off rinse aid indicator
- - Loading the Dishwasher
- . Detergent
- / Dishwasher Cycles
- The Energy Guide label was based on the Normal soil sensing cycle as follows: The unit was tested without any rinse aid (liquid) in the rinse aid dispenser 1b. A single dose of detergent was inserted into the detergent dispenser 1j, with no detergent...
- Only sanitizing cycles have been designed to meet the requirements of Section 6 of the NSF/ANSI Standard for Residential Equipment for soil removal and sanitization efficacy. There is no intention, either directly or indirectly, to imply that all cyc...
- 1 Operating the Dishwasher
- Operating the Dishwasher
- 9 WARNING
- Protection against unintentional operation
- AquaSensor
- Switching the appliance on
- Time display
- Delay start
- Wash cycle end
- Auto power off
- To change the setting:
- 1. Press the On/Off button (.
- 2. Hold down the selection button > X and press the Start button h until the display H indicates š:‹x (x can be any number).
- 3. Release both buttons.
- 4. Press the selection button > Xuntil the display H indicates ˜:‹x.
- 5. Press the selection button < 8 until the display corresponds with your requirements.
- 6. Press the Start button h.
- To change the setting:
- Switching off the appliance
- Interrupting the wash cycle
- 9 CAUTION
- Terminating the wash cycle (Reset)
- Changing the wash cycle
- Child Lock (panel lock)
- Intensive drying
- 1. Press the On/Off button (.
- 2. Hold down the selection button > Xand press Start button h until the display H indicates š:x (x can be any number).
- 3. Release both buttons.
- 4. Press selection button < 8 to switch the intensive drying feature on š:‹‚ or off š:‹‹.
- 5. Press Start button h to save setting.
- 2 Care and Maintenance
- 3 Troubleshooting
- --------
- 1 Operating the Dishwasher
- Table des matières
- fr-ca Notice d'utilisation
- ( Indications de sécurité 47
- ( CONSIGNES DE SÉCURITÉ IMPORTANTES 48
- ƒ Causes de pannes 53
- * Mise en marche 54
- , Produit de rinçage 57
- - Chargement du lave-vaisselle 59
- . Détergent 66
- / Cycles du lave-vaisselle 68
- 0 Options de cycles du lave-vaisselle 69
- 1 Mise en marche du lave-vaisselle 71
- 2 Entretien et maintenance 75
- 3 Dépannage 80
- 4 Service à la clientèle 86
- ‡ Déclaration de la garantie limitée du produit 87
- ( Indications de sécurité
- fr-ca Notice d'utilisation
- ( CONSIGNES DE SÉCURITÉ IMPORTANTES
- CONSIGNES DE SÉCURITÉ IMPORTANTES
- LISEZ ET CONSERVEZ CES INSTRUCTIONS
- Pour réduire le risque d'incendie, de choc électrique, ou de blessures graves, respectez les consignes suivantes :
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- 9 ATTENTION
- ƒ Causes de pannes
- * Mise en marche
- , Produit de rinçage
- Produit de rinçage
- Remarque :
- Ajout de produit de rinçage
- AVIS
- 1. Ouvrez le distributeur de liquide de rinçage 1b en appuyant sur le loquet du couvercle et en tirant celui-ci.
- 2. Ajoutez le produit de rinçage liquide au distributeur 1b à pleine capacité.Ne le remplissez pas outre mesure. Évitez tout déversement dans le trou d'aération.
- 3. Fermez le couvercle. Le couvercle doit être hermétiquement fermé jusqu'à l'encliquetage du loquet, pour garantir son étanchéité.
- 4. Essuyez tout excédent de produit de rinçage déversé lorsque le réservoir est plein.
- Conseil :
- AVIS
- Réglage de la quantité de produit de rinçage utilisé
- Réglage
- Quantité
- 1. Appuyez sur le bouton On/Off (Marche/Arrêt) (.
- 2. Maintenez enfoncée la touche de sélection > X et appuyez sur le bouton Start h jusqu'à ce que l'afficheur H indique •:‹x (x peut être un nombre quelconque). Relâchez les deux boutons.
- 3. Appuyez sur la touche de sélection > X jusqu'à ce que l'afficheur H indique §:‹†.
- 4. Appuyez sur la touche de sélection 8 pour sélectionner la valeur désirée.
- 5. Appuyez sur le bouton Start h pour enregistrer le paramètre.
- Désactivation de l'indicateur de produit de rinçage
- - Chargement du lave-vaisselle
- . Détergent
- Détergent
- AVIS
- Cycle de nettoyage
- Eau dure/ Souillure importante
- Eau à dureté moyenne/ Souillure moyenne
- Eau douce/ Souillure légère/
- Ajout de détergent
- / Cycles du lave-vaisselle
- L'étiquetage Energy Guide se base sur le cycle de détection du niveau de saleté Normal comme suit : l'unité a été testée avec un distributeur de produit de rinçage (liquide) vide 1b. Une seule dose de détergent a été introduite dans le dis...
- Seuls les cycles de désinfection ont été conçus de manière à respecter les exigences de la Section 6 de la norme NSF/ANSI relative aux Équipements à usage résidentiel destinés à l'élimination de salissures et à la désinfection efficace....
- 1 Mise en marche du lave-vaisselle
- Mise en marche du lave-vaisselle
- 9 AVERTISSEMENT
- Protection contre une opération involontaire
- AquaSensor
- Mise sous tension de l'appareil
- Affichage de l'heure
- Démarrage retardé
- Fin du cycle de nettoyage
- Auto power off (Arrêt automatique)
- Pour changer le réglage :
- 1. Appuyez sur le bouton On/Off (Marche/Arrêt) (.
- 2. Maintenez enfoncée la touche de sélection > X et appuyez sur le bouton Start h jusqu'à ce que l'afficheur H indique š:‹x (x peut être un nombre quelconque).
- 3. Relâchez les deux boutons.
- 4. Appuyez sur la touche de sélection > X jusqu'à ce que l'afficheur H indique ˜:‹x.
- 5. Appuyez sur la touche de sélection < 8 jusqu'à ce que l'afficheur corresponde à ce que vous souhaitez.
- 6. Appuyez sur le bouton Start h.
- Pour changer le réglage :
- Mise hors tension de l'appareil
- Interruption du cycle de nettoyage
- 9 ATTENTION
- Arrêt du cycle de nettoyage (réinitialisation)
- Changement du cycle de lavage
- Verrouillage automatique du panneau/à l'épreuve des enfants
- Séchage intensif
- 1. Appuyez sur le bouton On/Off (Marche/Arrêt) (.
- 2. Maintenez enfoncée la touche de sélection > X et appuyez sur le bouton Start h jusqu'à ce que l'afficheur H indique š:x (x peut être un nombre quelconque).
- 3. Relâchez les deux boutons.
- 4. Appuyez sur la touche de sélection < 8 pour activer š:‹‚ ou désactiver š:‹‹ la fonction de séchage intensif.
- 5. Appuyez sur Start h pour enregistrer le réglage.
- 2 Entretien et maintenance
- Entretien et maintenance
- Nettoyer le filtre du lave-vaisselle
- Filtres
- Bras gicleurs
- Pompe pour eaux résiduaires
- Rangement de l'appareil en cas d'inactivité
- Préparation de l'appareil pour l'hiver
- 3 Dépannage
- --------
- 4 Service à la clientèle
- ‡ Déclaration de la garantie limitée du produit
- 1 Mise en marche du lave-vaisselle
en-us Loading the Dishwasher
16
- Loading the
Dishwasher
Loadi ng the Di shwasher
Dishware material
Note: Before using your dishwasher
for the first time, check the
information in this section. Some
items are not dishwasher-safe and
should be hand washed; others
require special loading.
Loading the racks
For best dishwashing results,
observe the following when loading
the dishwasher:
■ Do not pre-wash items with
loosely attached food soil.
■ Remove all food particles, bones,
toothpicks and excessive grease.
■ Pre-treat items having burned-on,
baked-on or starchy soils.
■ Load dishes in the dishwasher
racks so the insides of bowls,
pots and pans are facing the
spray arms.
■ Avoid nesting and contact points
between dishes.
■ Separate items of dissimilar
metals. Use care to not block
movement of the spray arms.
Recommended
Aluminum Colored anodized alumi-
num may fade over time.
Minerals in your water may
cause the aluminum to
darken or spot. This can
usually be removed with a
soap-filled steel wool pad.
China, Crystal,
Stoneware
Some hand-painted utensils
may discolor, fade or spot.
Hand wash these utensils.
Position fragile glassware so
that it will not topple over or
come in contact with other
utensils during the wash
cycle.
Glass Make sure to use dish-
washer-safe glass. Milk
glass may discolor or
become yellow.
Non-stick Coat-
ings
Apply a light coating of veg-
etable oil to non-stick sur-
faces after drying.
Plastics Make sure the plasticware is
dishwasher-safe.
Stainless Steel,
Sterling Silver
and Silver
Plates
Load these so they do not
come in contact with other
metals, stainless steel dish-
washer tub walls or the
inner door.
Not Recommended
Acrylic Crazing or small cracks
throughout the acrylic, may
occur.
Adhesive-
Joined Pieces
Adhesives that join materi-
als such as plastic, wood,
bone, steel, copper, tin, etc.
may loosen.
Bone-Handled
Utensils
Handles may separate.
Iron Iron will rust. Hand wash
and dry immediately.
Non-Dishware
Items
Your dishwasher is intended
for use in cleaning ONLY
standard household dish-
ware and kitchenware.
Pewter, Brass,
Bronze
These items will tarnish.
Hand wash and dry immedi-
ately.
Tin Tin will stain. Hand wash
and dry immediately.
Wood Wooden bowls, wooden
utensils and utensils with
wooden handles can crack,
warp and lose their finish.