Use and Care Manual

Troubleshooting en-us
43
Issue Cause and troubleshooting
Food remnants on
dishware.
Dishware was placed too close together or rack is
overfilled.
1. Arrange dishware with sufficient space in be-
tween.
The spray jets must reach the surfaces of the
dishware.
2. Avoid points of contact.
Spray arm rotation is blocked.
▶ Arrange dishware so it does not obstruct spray
arm rotation.
Spray arm nozzles are blocked.
▶
Clean the Spray arms → Page38 .
Filters are dirty.
▶ Clean the filters.
→ "Cleaning filters", Page37
Filters are inserted incorrectly and/or not en-
gaged.
1. Insert the filters properly.
→ "Filter system", Page37
2. Twist filters into place.
Selected wash cycle is too light.
▶ Select a more intensive cycle.
Dishware has been precleaned too intensively.
Then the sensors choose a lighter cycle. Stub-
born remnants cannot be entirely removed.
▶ Only remove large remnants of food and do not
pre-rinse dishware.
Tall narrow containers in corner areas are not
rinsed out adequately.
▶ Do not position tall narrow containers at too
great an angle or in corner areas.
Upper rack on right and left not set to same
height.
▶ Set the upper rack on the right and left to the
same height.