Installation Guide

Installation Procedure en-us
11
4.6 Prepare Hoses and Power Cord
The dishwasher drain hose is configured for a sink on the
left side of the installation location. If your sink is on the
right side, you will need to reposition the drain hose
behind the dishwasher before installing.
1. If needed, unhook the strap and reposition the drain
hose per your requirements.(If your sink is to the left
side, leave the hose as it came.)
2. Position the drain hose, water inlet hose and the power
cord so they all run through the strap on the appropriate
side.
3. Attach the strap back in place to secure the hoses and
cord.
4.7 Install Dishwasher in Cabinet Space
To avoid scratching the floor, use floor protection and
caution when sliding the dishwasher into the cabinet.
NOTICE:
Avoid Hose Kinks
▶ Be careful while pushing dishwasher in. The hoses can
fold, kink or break, potentially causing an obstruction or
leak.
1. Feed the power cord through the low hole in the cabinet
first and then add the hoses.
2. Using both hands, push dishwasher 1/3 of the way into
the cabinet and STOP.
3. Pull the hoses and power cord through the hole in
cabinet as shown.
4. Push the unit 2/3 of the way into the opening and
STOP.
5. Reach into adjacent cabinet and pull hoses and excess
power cord completely out so they do not get kinked.