Interactive User Manual
Table Of Contents
- Table of contents
- en-us Operating instructions
- ( Safety Definitions 5
- ( IMPORTANT SAFETY INSTRUCTIONS 6
- ƒ Causes of Damage 10
- * Getting Started 11
- , Rinse Aid 14
- - Loading the Dishwasher 16
- . Detergent 22
- / Dishwasher Cycles 24
- 0 Dishwasher Cycle Options 25
- 1 Operating the Dishwasher 26
- 2 Care and Maintenance 30
- 3 Troubleshooting 35
- 4 Customer Service 40
- ‡ Statement of Limited Product Warranty 41
- ( Safety Definitions
- en-us Operating instructions
- ( IMPORTANT SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- READ AND SAVE THESE INSTRUCTIONS
- To reduce the risk of fire, electrical shock, or serious injury, observe the following:
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 CAUTION
- ƒ Causes of Damage
- * Getting Started
- , Rinse Aid
- Rinse Aid
- Note:
- Adding rinse aid
- NOTICE
- 1. Open the rinse aid dispenser 1b by pressing on the latch of the lid and pull it open.
- 2. Add liquid rinse aid to the dispenser 1b until it is full. Do not overfill. Avoid spilling into air vent hole.
- 3. Close the lid. Lid must be fully closed until it clicks in order to seal.
- 4. Wipe up any excess rinse aid that may have puddled when the dispenser reservoir is full.
- Tip:
- NOTICE
- Setting the amount of rinse aid used
- Setting
- Amount
- 1. Press the On/Off button (.
- 2. Hold down the function key # and press the Start button P until the display 8 indicates •:‹x or š:‹x (x can be any number). Release both buttons.
- 3. Press the function key # until the display 8 shows §:‹†.
- 4. Press the function key 3 to select the desired setting.
- 5. Press the Start button P to save the setting.
- Turning off rinse aid indicator
- - Loading the Dishwasher
- . Detergent
- / Dishwasher Cycles
- The Energy Guide label was based on the Normal soil sensing cycle as follows: The unit was tested without any rinse aid (liquid) in the rinse aid dispenser 1b. A single dose of detergent was inserted into the detergent dispenser 1j, with no detergent...
- Only sanitizing cycles have been designed to meet the requirements of Section 6 of the NSF/ANSI Standard for Residential Equipment for soil removal and sanitization efficacy. There is no intention, either directly or indirectly, to imply that all cyc...
- 1 Operating the Dishwasher
- Operating the Dishwasher
- 9 WARNING
- Protection against unintentional operation
- AquaSensor
- Switching the appliance on
- Time display
- Delay start
- Wash cycle end
- Auto power off
- To change the setting:
- 1. Press the On/Off button (.
- 2. Hold down the function key # and press the Start button P until the display 8 indicates š:‹x (x can be any number).
- 3. Release both buttons.
- 4. Press the function key # until the display 8 indicates ˜:‹x.
- 5. Press the function key 3 until the display corresponds with your requirements.
- 6. Press the Start button P.
- To change the setting:
- Switching off the appliance
- Interrupting the wash cycle
- 9 CAUTION
- Terminating the wash cycle (Reset)
- Changing the wash cycle
- Child Lock (panel lock)
- Intensive drying
- 1. Press the On/Off button (.
- 2. Hold down function key # and press Start button P until the display 8 indicates š:x (x can be any number).
- 3. Release both buttons.
- 4. Press function key # until the display 8 indicates the factory set value š:‹‹.
- 5. Press function key 3 to switch the intensive drying feature on š:‹‚ or off š:‹‹.
- 6. Press Start button P to save setting.
- 2 Care and Maintenance
- 3 Troubleshooting
- --------
- 1 Operating the Dishwasher
- Table des matières
- fr-ca Notice d'utilisation
- ( Indications de sécurité 47
- ( CONSIGNES DE SÉCURITÉ IMPORTANTES 48
- ƒ Causes de pannes 52
- * Mise en marche 53
- , Produit de rinçage 56
- - Chargement du lave-vaisselle 58
- . Détergent 65
- / Cycles du lave-vaisselle 67
- 0 Options de cycles du lave-vaisselle 68
- 1 Mise en marche du lave-vaisselle 70
- 2 Entretien et maintenance 74
- 3 Dépannage 79
- 4 Service à la clientèle 85
- ‡ Déclaration de la garantie limitée du produit 86
- ( Indications de sécurité
- fr-ca Notice d'utilisation
- ( CONSIGNES DE SÉCURITÉ IMPORTANTES
- CONSIGNES DE SÉCURITÉ IMPORTANTES
- LISEZ ET CONSERVEZ CES INSTRUCTIONS
- Pour réduire le risque d'incendie, de choc électrique, ou de blessures graves, respectez les consignes suivantes :
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- 9 AVERTISSEMENT
- 9 ATTENTION
- ƒ Causes de pannes
- * Mise en marche
- , Produit de rinçage
- Produit de rinçage
- Remarque :
- Ajout de produit de rinçage
- AVIS
- 1. Ouvrez le distributeur de liquide de rinçage 1b en appuyant sur le loquet du couvercle et en tirant celui-ci.
- 2. Ajoutez le produit de rinçage liquide au distributeur 1b à pleine capacité.Ne le remplissez pas outre mesure. Évitez tout déversement dans le trou d'aération.
- 3. Fermez le couvercle. Le couvercle doit être hermétiquement fermé jusqu'à l'encliquetage du loquet, pour garantir son étanchéité.
- 4. Essuyez tout excédent de produit de rinçage déversé lorsque le réservoir est plein.
- Conseil :
- AVIS
- Réglage de la quantité de produit de rinçage utilisé
- Paramètre
- Quantité
- 1. Appuyez sur le bouton On/Off (Marche/Arrêt) (.
- 2. Maintenez la touche enfoncée # et appuyez sur le bouton Start (Démarrer) P jusqu'à ce que l'afficheur 8 indique •:‹x ou š:‹x (x peut être un nombre quelconque). Relâchez les deux boutons.
- 3. Appuyez sur la touche de fonction # jusqu'à ce que l'afficheur 8 indique §:‹†.
- 4. Appuyez sur la touche de fonction 3 pour sélectionner la valeur désirée.
- 5. Appuyez sur le bouton Start (Démarrer) P pour enregistrer le paramètre.
- Désactivation de l'indicateur de produit de rinçage
- - Chargement du lave-vaisselle
- . Détergent
- Détergent
- AVIS
- Cycle de nettoyage
- Eau dure/ Souillure importante
- Eau à dureté moyenne/ Souillure moyenne
- Eau douce/ Souillure légère/
- Ajout de détergent
- / Cycles du lave-vaisselle
- L'étiquetage Energy Guide se base sur le cycle de détection du niveau de saleté Normal comme suit : l'unité a été testée avec un distributeur de produit de rinçage (liquide) vide 1b. Une seule dose de détergent a été introduite dans le dis...
- Seuls les cycles de désinfection ont été conçus de manière à respecter les exigences de la Section 6 de la norme NSF/ANSI relative aux Équipements à usage résidentiel destinés à l'élimination de salissures et à la désinfection efficace....
- 1 Mise en marche du lave-vaisselle
- Mise en marche du lave-vaisselle
- 9 AVERTISSEMENT
- Protection contre une opération involontaire
- AquaSensor
- Mise sous tension de l'appareil
- Affichage de l'heure
- Démarrage retardé
- Fin du cycle de nettoyage
- Auto power off (Arrêt automatique)
- Pour changer le réglage :
- 1. Appuyez sur le bouton On/Off (Marche/Arrêt) (.
- 2. Maintenez la touche # enfoncée et appuyez sur le bouton Start (Démarrer) P jusqu'à ce que l'afficheur 8 indique š:‹x (x peut être un nombre quelconque).
- 3. Relâchez les deux boutons.
- 4. Appuyez sur la touche de fonction # jusqu'à ce que l'afficheur 8 indique ˜:‹x.
- 5. Appuyez sur la touche de fonction 3 jusqu'à ce que l'afficheur corresponde à vos besoins.
- 6. Appuyez sur le bouton Start (Démarrer) P.
- Pour changer le réglage :
- Mise hors tension de l'appareil
- Interruption du cycle de nettoyage
- 9 ATTENTION
- Arrêt du cycle de nettoyage (réinitialisation)
- Changement du cycle de lavage
- Verrouillage automatique du panneau/à l'épreuve des enfants
- Séchage intensif
- 1. Appuyez sur le bouton On/Off (Marche/Arrêt) (.
- 2. Maintenez la touche # enfoncée et appuyez sur le bouton Start (Démarrer) P jusqu'à ce que l'afficheur8 indique š:‹x (x peut être un nombre quelconque).
- 3. Relâchez les deux boutons.
- 4. Appuyez sur la touche de fonction # jusqu'à ce que l'afficheur 8 indique la valeur réglée à l'usine š:‹‹.
- 5. Appuyez sur la touche de fonction 3 pour mettre la fonction Extra sec sur On (activée) š:‹‚ ou sur Off (désactivée) š:‹‹.
- 6. Appuyez sur le bouton Start (Démarrer) P pour enregistrer le réglage.
- 2 Entretien et maintenance
- Entretien et maintenance
- Nettoyer le filtre du lave-vaisselle
- Filtres
- Bras gicleurs
- Pompe pour eaux résiduaires
- Rangement de l'appareil en cas d'inactivité
- Préparation de l'appareil pour l'hiver
- 3 Dépannage
- --------
- 4 Service à la clientèle
- ‡ Déclaration de la garantie limitée du produit
- 1 Mise en marche du lave-vaisselle
9
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
8
Safe Operation
Use this dishwasher only for its
intended function, which is the
washing of household dishware and
kitchenware rated as dishwasher
safe.
Use only detergents or rinsing agents
recommended for use in a
dishwasher, and keep them out of
the reach of children.
9 CAUTION
When loading items to be
washed:
■ Locate sharp items so they
are not likely to damage the
door seal.
■ Load knives and other sharp
utensils with their HANDLES
UP to reduce the risk of
cut-type injuries.
■ Do not wash plastic items
unless they are marked
“dishwasher safe” or the
equivalent. For plastic items
not so marked, check the
manufacturer’s
recommendations.
■ Do not operate your
dishwasher unless all
enclosure panels are in
place.
■ Do not tamper with or
override controls and
interlocks.
Do not abuse, sit or stand on the
door or dish racks of the dishwasher.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
9 WARNING
CHILD SAFETY!
■ To reduce risk of injury, do
not allow children to play in
or on the dishwasher.
■ When children become old
enough to operate the
appliance, it is the
responsibility of the
parents/legal guardians to
ensure the children are
instructed in safe practices
by qualified persons.
NSF/ANSI 184 Certified residential
dishwashers are not intended for
licensed food establishments.