Use and Care Guide

en-us Operating the Dishwasher
30
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1. Press On/Off button (.
The LED’s go out. The wash cycle
is saved.
2. To continue the wash cycle, close
the door and press On/Off button
( again.
Note: Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button P again.
Terminating the wash cycle
(Reset)
Ter mi nat i ng the wa s h cycl e 1. Press and hold Start button P
for approximately 3 seconds until
the display reads ‹:‹‚.
2. Wait about 1 minute while the
dishwasher drains.
3. Press On/Off button (.
You may now power the dishwasher
back on and begin a new cycle if
desired.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
Child Lock (panel lock)
The child lock feature will lock the
panel while the dishwasher is in
operation to prevent a wash cycle
from being interrupted unintentionally
(e.g. by children).
To set the panel lock:
1. Start the desired wash cycle.
2. Hold down the button labeled with
a / symbol or the words ‘Child
Lock’ for approximately
3 seconds until the display reads
’–.
The panel lock is active.
’– will show in the display if any
button is pressed and the program
will not be reset.
To deactivate the panel lock, hold
down the button again for
approximately 3 seconds until the
display no longer reads ’–.
The panel lock is deactivated
automatically when the wash cycle
ends. In the case of a power outage,
the panel lock will remain active. The
panel lock has to be activated with
each new wash cycle.
Intensive drying
The final rinse uses a higher
temperature which improves the
drying result. The cycle time and
energy usage may be increased.
(Caution if utensils are delicate!)
This feature has two settings:
1. Press the On/Off button (.
2. Hold down function key # and
press Start button P until the
display 8 indicates •:x (x can
be any number).
3. Release both buttons.
š:‹‹ Off
š:‹‚ On