Installation Instructions

16
Adhesive
backed
cord clip
Leg Adjuster
Strap
2"
(5 cm)
A
lternate cable routing
8
• Place adhesive backed cord clip (provided in the installation kit)
5 inches from leg adjuster as shown in the figure above and route
power cord through the clip. Note:The length of cord measured
from the plastic back strap to the receptacle should be ≤ 47.25”
(1,200 mm).
• Plug the end of the supply cord into the back of the dishwasher.
• The outlet for the power supply cord should be located in a cabinet
or wall adjacent to the dishwasher cabinet. Do not plug dishwasher in
until all the steps of installation are complete.
Note: Only use the included power cord. If cord is missing order kit
SMZPC002UC through Customer Service.