Installation Guide

en-us Installation Procedure
8
4. Attach the hot water line to the elbow. Use two
wrenches to tighten, using one to stabilize and avoid
putting stress on the water inlet valve.
4.2 Attach Drain Hose
1. Flip unit back upright, making sure the waterline is not
pinched.
2. Facing the back of the unit, orient the drain hose toward
direction of sink.
IMPORTANT: Route hose toward sink PRIOR TO
connection. Do not turn after attachment.
3. Attach drain hose elbow to back of unit using pliers to
install the spring clamp
4.3 Pre-level the Dishwasher
Set the dishwasher to the correct height before it goes into
the cabinet.
1. Measure the height of the cabinet opening.
2. Raise the front of the dishwasher to approximately 1/2"
lower than the height of the opening by turning all three
feet.
The maximum height the unit can be raised to is 34.5"
(867.3 mm)
3. Use a level on the top front to see that the feet are
even.
4. Once the unit is at a satisfactory height, insert a leg
leveler locking screw in back foot.