Installation Guide
Table Of Contents
- Dishwasher
- en-us
- Table of contents
- 1 IMPORTANT SAFETY INSTRUCTIONS
- 2 Before you begin
- 3 Installation Preparation
- 4 Installation Procedure
- 4.1 Attach Water Inlet Hose
- 4.2 Visual Leak Check
- 4.3 Pre-level the Dishwasher
- 4.4 Attach Power Cord
- 4.5 Mounting Brackets
- 4.6 Prepare Hoses and Power Cord
- 4.7 Install Dishwasher in Cabinet Space
- 4.8 Level the Dishwasher
- 4.9 Outer Door Assembly
- 4.10 Secure the Dishwasher
- 4.11 Attach the Standard Toe Panel
- 4.12 Attach Plastic Toe Panel
- 5 Dishwasher Connection
- 6 Customer Service
- fr-ca
- Table des matières
- 1 IMPORTANTES CONSIGNES DE SÉCURITÉ
- 2 Avant de commencer
- 3 Préparation avant l’installation
- 4 Procédure d’installation
- 4.1 Fixer le flexible d’arrivée d’eau
- 4.2 Contrôle visuel des fuites
- 4.3 Mise à niveau préalable du lave-vaisselle
- 4.4 Fixer le cordon d’alimentation
- 4.5 Équerres de fixation
- 4.6 Préparer les tuyaux et le cordon d’alimentation
- 4.7 Installer un lave-vaisselle dans un meuble
- 4.8 Mise à niveau du lave-vaisselle
- 4.9 Assemblage de la porte extérieure
- 4.10 Fixer le lave-vaisselle
- 4.11 Fixer la plinthe standard
- 4.12 Fixer la plinthe en plastique
- 5 Raccordement du lave-vaisselle
- 6 Service à la clientèle
- es-mx
- Tabla de contenidos
- 1 INSTRUCCIONES DE SEGURIDAD IMPORTANTES
- 2 Antes de empezar
- 3 Preparación para la instalación
- 4 Procedimiento de instalación
- 4.1 Acoplar la manguera de entrada de agua
- 4.2 Comprobación visual de fugas
- 4.3 Nivelar provisionalmente el lavavajillas
- 4.4 Acoplar el cable de alimentación
- 4.5 Soportes de montaje
- 4.6 Preparar las mangueras y el cable de alimentación
- 4.7 Instalar el lavavajillas en el espacio del gabinete
- 4.8 Nivelar el lavavajillas
- 4.9 Montaje de la puerta exterior
- 4.10 Fijar el lavavajillas
- 4.11 Acoplar la placa protectora del zócalo estándar
- 4.12 Acoplar la placa protectora del zócalo de plástico
- 5 Conexión del lavavajillas
- 6 Servicio de atención al cliente
en-us Installation Procedure
12
6. Finally, push the unit in until flush with cabinet door.
4.8 Level the Dishwasher
Now that the dishwasher is in the cabinet, check the levels
again.
1. Level side to side by turning feet clockwise to raise or
counter-clockwise to lower front.
2. Level front to back by turning center screw clockwise to
raise or counter-clockwise to lower the back.
3. Use a level to check that your dishwasher is level.
Check that the countertop is level and adjust the
dishwasher to the countertop.
4. Make sure the top of the door is no less than 1/4"
(6mm) from the underside of the counter.
4.9 Outer Door Assembly
▶ Follow the instructions for outer door assembly on the
fully integrated template.
Note:The door panel should weigh between 9 and 18 lbs,
be at least 3/4" thick, and not exceed 30 1/8" in length.