User Manual

aus Fault, what to do?
24
Fault table
Fault Cause Remedial action
“Check water supply”
display ` lights up.
Supply hose kinked. Install supply hose without kinks.
Tap turned off. Turn on the tap.
Tap jammed or calcified. Turn on the tap.
Flow rate must be min. 10 l/min.
when water supply is open.
Filter in the water supply blocked. Switch off the appliance and pull out
the mains plug. Turn off the tap. Unscrew
water connection.
Clean filter in the supply hose. Screw water
connection on again. Check for leaks.
Reconnect power supply. Switch on
the appliance.
Filters 1J are soiled or
blocked.
Clean filters.
(See Cleaning and maintenance)
Waste water hose
is blocked or kinked.
Install hose without kinks, remove any
residue.
Siphon connection still sealed. Check connection to siphon and open if
required.
Waste water pump blocked
or cover on the waste water
pump is not locked in position.
Lock cover correctly.
(See Waste water pump)
Display “Check water
supply” ` flashes.
A technical fault has probably
occurred.
Switch off appliances with the ON/OFF
switch (. After a short time restart
the appliance.
If the problem recurs, turn off the tap, pull
out the mains plug and call customer
service.
Displays flash. Door not closed properly. Close the door. Ensure that no objects
(utensil, fragrance dispenser) are protruding
over the basket and preventing the door
from closing.