User Manual

Fault, what to do? aus
27
Detergent residue Detergent dispenser cover
blocked by utensils and therefore
does not open fully.
Detergent dispenser cover must not be
obstructed by utensils.
Do not place utensils or fragrance dispenser
in the tablet collecting tray.
Detergent dispenser cover
blocked by the tablet.
Tablet must be inserted flat and not upright.
Tablets used in the quick or short
programme.
Dissolving time of the detergent
is not reached in the selected
short programme.
Dissolving time of tablets too long for
a quick or short programme.
Use a detergent powder or select a more
intensive programme.
Washing effect and dissolving
performance are reduced after
a prolonged storage time or
detergent is very lumpy.
Change detergent.
Water stains on plastic
parts
Droplet formation on plastic
surface is physically unavoidable.
After drying, water stains are
visible.
Use a more intensive programme (more
water changes).
Arrange utensils in a sloping position.
Use rinse aid.
Washable or water-soluble
coatings in the container or
on the door.
Detergent substances are
deposited. These coatings cannot
usually be removed with
chemicals (appliance cleaner, ...).
Change detergent brand.
Clean appliance mechanically.
Only for glasses: Initial glass
corrosion – can only apparently
be wiped off.
See Glass and utensil damage.
White, stubborn coatings;
limescale on the utensils,
container or door.
Detergent substances are
deposited. These coatings cannot
usually be removed with
chemicals (appliance cleaner, ...).
Change detergent brand.
Clean appliance mechanically.
3 in 1 detergent or bio/eco
detergent not effective enough.
Use or use separate detergents (proprietary
detergent, salt, rinse aid).
Underdosing of detergent. Increase detergent dosage or change
detergent.
Too weak rinse programme
selected.
Select a more intensive rinse programme.
Fault Cause Remedial action