Operation Manual

en Water softening system/special salt
14
Using special salt
Top up the special salt as soon as the
salt refill indicator @ lights up in the
control panel. Always top up the special
salt immediately before switching on the
dishwasher. This ensures that overrun
special salt solution is immediately
rinsed out and that corrosion in the
washing tank cannot occur.
Caution!
Detergent will destroy the water
softening unit! Never pour detergent into
the dispenser for special salt.
Top up the special salt as follows:
1. Undo the screw plug on the
dispenser 1R.
2. Fill the dispenser with water
(required only when switching on the
appliance for the first time).
3. Add special salt as illustrated(do not
use table salt or tablets).
The water is displaced and runs out.
*Depending on the features of your
dishwasher
Using detergent with a salt
component
Detergent with a salt component In general, you can use detergent with a
salt component up to a water hardness
level of 21 °dH (37 °fH, 26 °Clark,
3.7 mmol/L) without adding special salt.
Above a water hardness value of 21
°dH, use additional special salt.
Switching off salt refill
indicator/water softening unit
Switching off water softening unit If the salt refill indicator @ bothers you
(e.g. if you are using a combination
detergent with a salt component), you
can switch off the salt refill indicator.
Proceed as described under "Setting
water softening unit" and set the value
to •:‹‹. The water softening unit and
the salt refill indicator are switched off.
