Installation Instructions

For a large port, use the drain hose as it is.

1. For a small port, insert the rubber drain hose adaptor

into the drain hose end.

2. Obtain the Rubber Drain Hose Adaptor (J) spring

clamp from the Dishwasher Installation Kit (do not

substitute).

3. Insert the dishwasher drain hose into the end of the

drain hose (see Figure 12. Be sure to fully insert the

drain hose.

4. Use the clamp provided to attach the Rubber Drain Hose

Adaptor to the house plumbing as shown in Figure 13.

The dishwasher can be secured into its enclosure in 2 ways:

NOTE: If your dishwasher opening width measures >18″

(458

mm) use the TOP MOUNT mounting methods. If your

dishwasher opening width measures 18″ (458 mm) use

the SIDE MOUNT mounting method.

Figure 13

Figure 12

Before installing the supplied countertop mounting

brackets, decide which method of securing the

dishwasher into its enclosure will be used. Once the

mounting brackets are installed on the dishwasher,

removing them is difficult and will damage the

mounting brackets and the dishwasher.

Installation of Mounting Brackets

Installation of Rubber Drain Hose Adaptor

Top Mount is used for countertops made of wood or other

materials that can be easily drilled, or for openings

wider than 18". Orient the mounting brackets as shown

in Figure 14 and position the two small tabs on the

mounting brackets over the two slots on the

dishwasher’s front corners. Push the mounting brackets

down firmly to insert the tabs into the slots.

Side Mount is for countertops made of marble,

granite, or other very hard materials that cannot be

easily drilled. Also, it is for for openings that are 18".

Insert a side mount force distributor (M) in each side

as shown in Figure 15.

Figure 14

Top Mount

Torx T 20

Figure 15

Side Mount