Instruction manual

aus
7
Filling the salt dispenser
Salt must always be filled before the
appliance is switched on, so that excess
salt solution is immediately flushed away
to prevent corrosion.
Open the screw-type cap of the
compartment
24 .
Before using the appliance for the first
time, pour about 1 litre of water in the
salt container.
Then refill with salt (not cooking salt)
until the salt container is full
(max. 1.5 kg). When you refill the salt,
water is being displaced and drains off.
If the switch is set to ”0”, it is not necessary
to add any salt, as none is consumed
while the dishwasher is operating. If the
switch is set between ”1” and ”3”, then salt
must be added.
Warning
Do not pour detergent into the container
for special salt. This would destroy the
water softener.
LOW SALT indicator
Salt should be added as soon as the
coloured dot in the lid on the salt container
24 is no longer visible.
Depending on the washing frequency and
the hardness setting, the regeneration salt
may not have to be topped up for several
months.
Adding rinse aid
The rinse aid is required for stain-free
utensils and clear glasses.
Use only rinse aid for domestic
dishwashers.
Open the cover on the rinse-aid
dispenser
29 . To do this, press the
mark (1
) on the cover and
simultaneously lift the cover on the
control plate (2
).
Carefully pour in the rinse aid to just
below the edge of the filler opening.
Close the lid, ensuring that you hear it
snap closed.
To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with a cloth.