Installation and Operating Guide
Operation instructions
55
Greentherm T9900 SE/i – 6 720 813 635 (2022/01)
Fig. 50 160kBTU appliance gas conversion kit
▶Tighten the four screws.
▶ Open the gas supply valve.
▶ Turn On the appliance.
▶ Open a faucet and check for gas leak (e.g. use leak detector
fluid, like water and soap, over and around the metal plate)
and act accordingly.
▶ Place the front cover in the appliance.
▶Access the Technical Settings menu (section 6.6).
▶Access to menu P7 Gas Type.
Display shows appliance gas type.
▶ Use the symbols or to choose gas type LPG.
▶Touch the symbol .
The display blinks to confirm the change.
The appliance will go through an initialization process.
▶ Update “TYPE OF GAS” in the rating plate of the appliance
using the label provided with the conversion plates.
▶Confirm combustion adjustment and, if necessary, adjust
Gas and Air flow parameters, see chapter 8.12 for more
information.
6.9 Wi-Fi connection
Only available in T9900 SEi model. For T9900 SE160/199
models, a wireless connectivity accessory is available with Wi-
Fi accessory module.
6.9.1 Wi-Fi activation
Before activating Wi-Fi module,
▶ Unplug the appliance from the power supply.
The Wi-Fi module must be activated within 60 minutes after
plugging in the appliance to the power supply.
If an error message is displayed or cannot configure Wi-Fi
menu.
▶ See section 6.9.3 "Problem solving to activate Wi-Fi".
▶ Plug in the appliance to the power supply.
▶ Access to information / adjustments menu.
▶ Touch the symbol .
Display shows P4 Information.
▶ Touch the symbol until the display shows SA
Settings.
▶ Touch the symbol .
▶ Use the symbols or to select A7 Wireless
Connectivity
▶ Touch the symbol .
Display shows,
– WF Wi-Fi
▶ Touch the symbol .
Activate Wi-Fi module
Two options are available to activate Wi-Fi module in the
appliance;
▶ Connect the appliance to a network (SC Scan)
-or-
▶ Configure Hotspot menu in the appliance (HT Hotspot)
(This option is generally chosen in case there is no
domestic Wi-Fi connection available.)
How to connect the appliance to a network, SC Scan menu,
▶ Use the symbols or to select SC Scan.
▶ Touch the symbol .
Display shows list of available networks.
▶ Use the symbols or to select the Wi-Fi network.
▶ Touch the symbol .
Insert network password.