Operation Manual
16
B O S C H
* Model dependent
ENglISH
If this function is selected, the risk of shiny marks
on the garment due to the ironing is reduced.
When the “AntiShine” function is selected, the
blue light inside the temperature control comes
on.
The steam regulator (3) is used to adjust the
amount of steam produced when ironing.
Temperature
Recommended position of
1 2 3
•
eco
•
1 2 3
•
eco
•
max
max
max
max
1 2 3
•
eco
•
1 2 3
•
eco
•
max
max
max
max
1 2 3
•
eco
•
1 2 3
•
eco
•
max
max
max
max
1 2 3
•
eco
•
1 2 3
•
eco
•
max
max
max
max
i-Temp
1 2 3
•
eco
•
1 2 3
•
eco
•
max
max
max
max
AntiShine
1 2 3
•
eco
•
max
max
1 2 3
•
eco
•
max
max
☞
For better ironing results, iron the last
strokes without steam to dry the garment.
shot
This can be used to remove stubborn
wrinkles or to press in a sharp crease or
pleat.
2. Press the shot of steam button
repeatedly with intervals of at least 5 seconds.
This can be used to remove creases from
hanging clothes, curtains etc.
2. Hang article of clothing on a clothes hanger.
3. Operate the iron in a vertical position at a
distance of 10 cm / 4 in, and press the shot of
steam button
at least 5 seconds.
This enables the iron to be used for dry
ironing.
position.
DripStop
lf the temperature is set too low, the steam is
automatically switched off to avoid dripping.
There may be an audible click when this occurs.
This can be used to remove stubborn wrinkles.
Do not use the spray function with silk.
The “SensorSecure” function switches off
the iron when the handle is no longer
gripped, thus increasing safety and saving
energy.
1. Plug in the iron.
the handle is not gripped, and will show a
continuous light when the handle is gripped.
3. If the iron handle is released for more
than 10 seconds, the iron will stop heating
automatically.