Operation Manual

14
A
Trouble shooting
Problem Possible causes Solution
The steam generator
does not come on.
• There is a connection problem.
• The main power button is not
switched on.
• Check the mains cable, the plug
and the socket.
• Switch the main power button (9)
to the on position.(“I”)
The iron does not
heat up.
• The main power button is not
switched on.
• The temperature control knob is
set to the “min” position.
• Switch the main power button (9)
to the on position.(“I”)
• Set the temperature control knob
(11) to the desired position.
4. Fill the boiler with 500 ml of fresh water.
5. Shake the base unit for a few moments
and then empty it completely over a sink or
bucket.
6. To obtain the best result, we recommend that
this operation is done twice
7. Close the cap
Cleaning & Maintenance
Important:
Always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
1. After ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with
a damp cloth.
3. If the soleplate is soiled with dirt or scale,
clean it with a damp cloth.
4. Never use abrasive products or solvents.
Storing the appliance (D)
1. Set the main power to the “0” position and
disconnect the mains cable.
2. Always allow the appliance to cool down
before storing it.
3. Place the iron on the iron pad, standing on the
soleplate.
4. Empty the boiler and store the mains cable and
the steam hose in the storage compartment.
Do not wrap the cords too tight.
5. Use the carrying handles (17) on the sides
when moving the appliance.
Fabric protection soleplate
cover (E)
(depending on the model)
The fabric-protection soleplate cover is used for
steam-ironing delicate garments at maximum
temperature without damaging them. Use of the
soleplate cover also does away with the need for
a cloth to prevent shine on dark materials.
It is advisable to first iron a small section on the
inside of the garment to see if it is suitable.
To attach the soleplate cover to the iron, place
the tip of the iron into the end of the soleplate
cover and pull the elastic strap over the lower
rear of the iron until it fits tightly. To release the
soleplate cover, pull the elastic strap and remove
the iron.
The fabric-protection soleplate cover may
be purchased from the customer service or
specialist shops:
Accessory code
(After-sales)
Name of accessory
(Specialist outlets)
571510 TDZ2045
Tips to help you save energy
Steam production consumes the most energy.
To help minimise the energy used, follow the
advice below:
• Start by ironing the fabrics that require
the lowest ironing temperature. Check the
recommended ironing temperature in the
label on the garment.
• Try to iron the fabrics while they are still damp
and reduce the steam setting.
• If you tumble dry your fabrics before ironing
them, set the tumble drier on the ‘iron dry’
programme.
• If the fabrics are damp enough, you can iron
without steam.
en
Y